TLE5010 Datasheet, PDF (15/56 Pages) Infineon Technologies AG – GMR Based Angular Sensor

TLE5010
Draft
5
Electrical and Magnetic Parameters
Electrical and Magnetic Parameters
5.1
Electrical Parameters
These are all parameters over operating range, unless otherwise specified.
Unless individually specified, typical values correspond to a supply voltage V_DD = 5.0 V
and 25°C.
All other values correspond to - 40°C < T_J < 150°C
Table 4
Electrical Parameters
Parameter
Symbol Limit Values
Unit Notes
Supply Current ¹⁾
POR Level
POR Hysteresis
Power On Time
I_DD
V_POR
V_PORhy
t_Pon
min.
-
-
2.0
-
50
typ. max.
15 20
-
21
2.3 2.9
30 -
100 200
PLL Jitter
ADC Noise ⁵⁾
Input Signal
Low Level
Input Signal
High Level
Capacitance of
SSC Data Pin
t_{PLLjit_S}
t_{PLLjit_L}
N_ADC
V_L
-
-
-
-0.35
1.3 2.0 ²⁾
3.0 3.9
1 2.2
2
4.4²⁾
-
0.3 V_DD
V_H
0.7 V_DD -
C_LDATA -
4
V_DD
+0.35
6 ²⁾
mA V_DD = 4.5 to 5.5V
V_DD = 6.5 V
V Power On Reset
mV
µs V_DD > V_DDmin & after
first edge on f_CLK
ns short term ³⁾
long term ⁴⁾
digits 1 σ @ FIR_BYP = 0
1 σ @ FIR_BYP = 1
V Tested only at DATA
pin as structures of
V
all pins are identical
pF Internal
1) _{Without external pull-up resistor for SSC-Interface}
2) _{Not tested}
3) _{From pulse to pulse}
4) _{Accumulated over 1 ms}
5) _{ADC noise in respect to the peak ADC value specified in “Signal Processing” on Page 23.}
Noise tested using 1 σ of 100 sample values from Angle Test “000”
Preliminary Data Sheet
15
V 0.9, 2007-05