V23818-N15-L616 Datasheet, PDF (14/20 Pages) Infineon Technologies AG – Small Form Factor Single Mode 1300 nm Multirate up to 2.5 Gbit/s Transceiver 2x10 Pinning with LC™ Connector, with Collar

V23818-N15-L6xx
Technical Data
Receiver Electro-Optical Characteristics
Receiver
Symbol
Limit Values
Unit
min.
typ.
max.
Sensitivity (Average Power)¹⁾ P_IN
Saturation (Average Power) P_SAT
0
Signal Detect Assert Level²⁾ P_SDA
Signal Detect Deassert Level³⁾ P_SDD
–30
Signal Detect Hysteresis
P_SDA
3
–P_SDD
Signal Detect Assert Time²⁾
t_ASS
Signal Detect Deassert Time³⁾ t_DAS
Data Output High Voltage
DC/DC ⁴⁾
V_OH–V_CC –1110
–19
–19
0.1
0.35
–650
dBm
dBm
dBm
dBm
dB
ms
ms
mV
Differential Data Output
Voltage Swing AC/AC⁴⁾
V_ODpk-pk 1000
2000
mV
Data Output Low Voltage
DC/DC⁴⁾
V_OL–V_CC –1800
–1300 mV
Signal Detect Output High
Voltage LVPECL^{5), 6)}
V_SDH–V_EE V_CC
–1200
V_CC
mV
– 820
Signal Detect Output Low
Voltage LVPECL^{5), 6)}
V_SDL–V_EE V_CC
– 1900
V_CC
mV
– 1580
Signal Detect Output High
V_SDH
2.4
V
Voltage LVTTL^{5), 7)}
Signal Detect Output Low
Voltage LVTTL^{5), 7)}
V_SDL
0.5
V
Photo Detector Bias
Responsivity ⁸⁾
PDBias_RES 0.5
1.0
A/W
Photo Detector Bias Offset
Reflectance
PDBias_OFF 5
P_REF
15
µA
–33
–27
dB
1) _{Minimum average optical power at which the BER is less than 1x10}–10_{. Measured with a 2}23_{–1 NRZ PRBS.}
2) _{An increase in optical power above the specified level will cause the Signal Detect to switch from a low state}
to a high state (high active output).
3) _{A decrease in optical power below the specified level will cause the Signal Detect to switch from a high state}
to a low state.
4) _{Load is 100 Ω differential.}
5) _{Internal Load is 510 Ω to GND, no external load necessary. Signal Detect is a high active output. High level}
means signal is present, low level means loss of signal.
6) _{For V23818-N15-L616.}
Data Sheet
14
2003-09-10