TLE7183F Datasheet, PDF (10/28 Pages) Infineon Technologies AG – 3-Phase Bridge Driver IC

TLE7183F
General Product Characteristics
Pos. Parameter
Symbol
Limit Values
Unit Conditions
Min.
Max.
4.2.9 Voltage difference CB2-VDH
V_CB2
-0.3
25
V
Operation mode
4.2.10 Junction temperature
T_j
-40
150
°C
1) max ratings for Tj has to be considered as well
2) For proper start up minimum Vs=6.5V is required
3) Duty cycle is referred to the high side input command (IHx); The duty cycles can be driven continuously and fully operational
4) total current consumption from power net (Vs and VDH)
Note: Within the functional range the IC operates as described in the circuit description. The electrical
characteristics are specified within the conditions given in the related electrical characteristics table.
4.3
Default State of Inputs
Table 1 Default State of Inputs
Characteristic
State
Default state of ILx (if ILx left open)
Low
Default state of IHx (if IHx left open)
High
Default state of ENA (if ENA1 left open) Low
Default state of ENA (if ENA2 left open) Low
Default state of INH (if INH left open)
Low
Default State of sense amplifier output V_O Zero ampere equivalent
(ISP=ISN=0V)
Status of the device and the outputs when Device active and outputs functional
ENA1=ENA2=INH='1'
Pull up or pull down integrated resistors 30kΩ +/-40%
Ixx, ENA
Pull down integrated resistor INH
45kΩ +/-40%
Remark
Low side MOSFETs off
High side MOSFETs off
Device outputs disabled
Device outputs disabled
Sleep mode, I_Q < 30 µA
–
Vs=5.5..28V
–
–
Note: The load condition “C=22nF; R_Load=1Ω” in the paragraph “Electrical characteristics / Dynamic charactersitic” means that
R_Load is connected between the output Gxx and the positive terminal of the C. The negative terminal of the C is connected
to GND and the corresponding Sxx. The voltage is measured at the positive terminal of the C.
Data Sheet
10
V2.1, 2008-04-30