HC2509C Datasheet, PDF (1/6 Pages) Hynix Semiconductor – Phase-Locked Loop Clock Distribution for Synchronous DRAM Applications

HC2509C
March 1999
HC2509C
Features
l Phase-Locked Loop Clock Distribution for
Synchronous DRAM Applications
l Supports PC-100 and Meets “PC100 SDRAM
registered DIMM Specification Rev. 1.2”
l Distributes One Clock Input to One Bank of Five
and One Bank of Four Outputs
l No External RC Network Required
l External Feedback (FBIN) Pin is Used to
Synchronize the Outputs to the Clock Input
l Separate Output Enable for Each Output Bank
l Operates at 3.3 V Vcc
l 125 MHz Maximum Frequency
l On-chip Series Damping Resistors
l Support Spread Spectrum Clock(SSC)
Synthesizers
l ESD Protection Exceeds 3000 V per MIL-STD-
883, Method 3015 ; Exceeds 350 V Using
Machine Model ( C = 200 pF, R = 0 )
l Latch-Up Performance Exceeds 400 mA per
JESD 17
l Packaged in Plastic 24-Pin Thin Shrink Small-
Outline Package
Pin Configuration
TSSOP 24 PACKAGE
(TOP VIEW)
AGND
1
Vcc
2
1Y0
3
1Y1
4
1Y2
5
GND
6
GND
7
1Y3
8
1Y4
9
Vcc
10
1G
11
FBOUT
12
24
CLK
23
AVcc
22
Vcc
21
2Y0
20
2Y1
19
GND
18
GND
17
2Y2
16
2Y3
15
Vcc
14
2G
13
FBIN
1
General Description
The HC2509C is a low-skew, low jitter, phase-locked
loop(PLL) clock driver, distributing high frequency
clock signals for SDRAM.
The HC2509C operates at 3.3V Vcc and provides
integrated series-damping resistors that make it ideal
for driving point-to-point loads. The propagation delay
from the CLK input to any clock output is nearly zero.
One bank of five outputs and one bank of four outputs
provide nine low-skew and low-jitter clocks. Each
bank of outputs can be enabled or disabled
separately via the control inputs (1G and 2G). Output
signal duty cycles are adjusted to 50 percent,
independent of the duty cycle at CLK.
The HC2509C is specially designed to interface with
high speed SDRAM applications in the range of
25MHz to 125MHz and includes an internal RC
network which provides excellent jitter characteristics
and eliminates the needs for external components.
For the test purpose, the PLL can be bypassed by
strapping AVcc to ground.
The HC2509C is characterized for operation from 0°C
to 85°C.
Function Table
INPUTS
1G 2G CLK
X
X
L
L
L
H
L
H
H
H
L
H
H
H
H
OUTPUTS
1Y
(0:4)
L
L
L
H
H
2Y
(0:3)
L
L
H
L
H
FBOUT
L
H
H
H
H