HCPL9000 Datasheet, PDF (11/12 Pages) Agilent(Hewlett-Packard) – High Speed Digital Isolators

Propagation Delay, Pulse Width
Distortion and Propagation Delay Skew
Propagation Delay is a figure of
merit, which describes how
quickly a logic signal propagates
through a system as illustrated in
Figure 3.
The propagation delay from low to
high, t_PLH, is the amount of time
required for an input signal to
propagate to the output, causing
the output to change from low to
high. Similarly, the propagation
delay from high to low, t_PHL, is the
amount of time required for the
input signal to propagate to the
output, causing the output to
change from high to low.
Pulse Width Distortion, PWD, is
the difference between t_PHL and
t_PLH and often determines the
maximum data rate capability of
a transmission system. PWD can
be expressed in percent by
dividing the PWD (in ns) by the
minimum pulse width (in ns)
being transmitted. Typically, PWD
on the order of 20 – 30% of the
minimum pulse width is tolerable.
Propagation Delay Skew, t_PSK,
and Channel-to-Channel Skew,
t_CSK, are critical parameters to
consider in parallel data trans-
mission applications where
synchronization of signals on
parallel data lines is a concern.
INPUT
V_IN
OUTPUT
V_OUT
tPLH
90%
10%
50%
tPHL
90%
10%
Figure 3. Timing Diagrams to Illustrate Propagation Delay, t and t .
PLH
PHL
5 V CMOS
0V
VOH
2.5 V CMOS
VOL
V_IN
V_OUT
V_IN
V_OUT
50%
2.5 V
CMOS
t_PSK
50%
DATA
INPUTS
CLOCK
2.5 V
CMOS
DATA
OUTPUTS
CLOCK
t_PSK
t_PSK
Figure 5. Parallel Data Transmission.
Figure 4. Timing Diagrams to Illustrate
Propagation Delay Skew.
If the parallel data is being sent
through channels of the digital
isolators, differences in propaga-
tion delays will cause the data to
arrive at the outputs of the
digital isolators at different
times. If this difference in
propagation delay is large
enough, it will limit the maxi-
mum transmission rate at which
parallel data can be sent through
the digital isolators.
t_PSK is defined as the difference
between the minimum and
maximum propagation delays,
either t_PLH or t_PHL, among two or
more devices which are operating
under the same conditions (i.e.,
the same drive current, supply
voltage, output load, and operat-
ing temperature). t_CSK is defined
as the difference between the
minimum and maximum propaga-
tion delays, either t_PLH or t_PHL,
among two or more channels
within a single device (applicable
to dual and quad channel de-
vices) which are operating under
the same conditions.
As illustrated in Figure 4, if the
inputs of two or more devices are
switched either ON or OFF at the
same time, t_PSK is the difference
between the minimum propaga-
tion delay, either t_PLH or t_PHL, and
the maximum propagation delay,
either t_PLH or t_PHL.
As mentioned earlier, t_PSK, can
determine the maximum parallel
data transmission rate. Figure 5
shows the timing diagram of a
typical parallel data transmission
application with both the clock
and data lines being sent through
the digital isolators. The figure
shows data and clock signals at
the inputs and outputs of the
digital isolators. In this case, the
data is clocked off the rising edge
of the clock.
11