HMC6001LP711E Datasheet, PDF (8/18 Pages) Hittite Microwave Corporation – WiGig Single Carrier Modulations

v00.1112
Table 5. Absolute Maximum Ratings
Input Power to IC
0 dBm
VDD = 2.7 V
2.85 Vdc
VCC = 2.7 V
2.85 Vdc
VDD_PLL = 1.35 V
1.6 Vdc
VDDD = 1.35 V
1.6 Vdc
GND
0± 50 mV
Serial Digital Interface Input Voltage
1.5 Vdc
Ref CLK Input (AC coupled)(each)
0.75 Vp-p
Baseband Outputs (BB, FM)
0.75 Vp-p
Junction Temperature
125°C
Continuous Pdiss (T=85°C)
(derate 45 mW/°C above 85°C)
0.760 W
Thermal Resistance (Rth)
(Junction to ground paddle)
22.16 °C/W
Storage Temperature
-55°C to 150°C
Operating Temperature
-40°C to 85°C
ESD Sensitivity (HBM)
Class 1A
Outline Drawing
HMC6001LP711E
MILLIMETERWAVE RECEIVER
57 - 64 GHz
Stresses above those listed under Absolute Maximum
Ratings may cause permanent damage to the device.
This is a stress rating only; functional operation of the
device at these or any other conditions above those
indicated in the operational section of this specification
is not implied. Exposure to absolute maximum rating
conditions for extended periods may affect device
reliability.
NOTES:
1. ALL DIMENSIONS ARE IN INCHES [MM]
2. LEAD SPACING TOLERANCE IS NON-CUMULATIVE.
3. PAD BURR LENGHT SHALL BE 0.15 mm MAX. PAD BURR HEIGHT SHALL BE 0.05 mm MAX.
4. PACKAGE WARP SHALL NOT EXCEED 0.05 mm
5. ALL GROUND LEADS AND GROUND PADDLE MUST BE SOLDERED TO PCB RF GROUND
6. REFER TO HITTITE APPLICATION NOTE FOR SUGGESTED PCB LAND PATTERN.
Table 6. Package Information
Part Number
Package Body Material
HMC6001LP711E
RoHS-compliant Low Stress Injection
Molded Plastic Silica and Silicon
Lead Finish
100% matte Sn
[1] 4-Digit lot number XXXX
MSL Rating
MSL3
Package Marking
H6001
XXXX
For price, delivery and to place orders: Hittite Microwave Corporation, 2 Elizabeth Drive, Chelmsford, MA 01824
Phone: [phone] Fax: [phone] Order On-line at www.hittite.com
8
Application Support: Phone: [phone] or [e-mail]