|
HB288032MM1 Datasheet, PDF (42/80 Pages) Hitachi Semiconductor – MultiMediaCard 32 MByte | |||
|
◁ |
HB288032MM1
Status
Bits Identifier
Type Value
Description
Clear condition
31 OUT_OF_RANGE E R â0â= no error
â1â= error
The commands argument was out C
of allowed range for this card.
30 ADDRESS_ERROR E R X â0â= no error
â1â= error
A misaligned address, which did C
not match the block length was
used in the command.
29 BLOCK_LEN_ERRO E R â0â= no error
R
â1â= error
The transferred block length is not C
allowed for this card or the
number of transferred bytes does
not match the block length
28 ERASE_SEQ_ERR E R â0â= no error
OR
â1â= error
An error in the sequence of erase C
commands occurred.
27 ERASE_PARAM E X â0â= no error
â1â= error
An invalid selection, sectors or C
groups, for erase.
26 WP_VIOLATION E R X â0â= not protected The command tried to write a
C
â1â= protected write protected block.
25 CARD_IS_LOCKED S X â0â= card
When set, signals that the card is A
unlocked
locked by the host.
â1â= card locked
24 LOCK_UNLOCK_ E R X â0â= no error
FAILED
â1â= error
Set when a sequence or
C
password error has been detected
in lock/unlock card command or it
there was an attempt to access a
locked card.
23 COM_CRC_ERROR E R â0â= no error
â1â= error
The CRC check of the previous B
command failed.
22 ILLEGAL_COMMAN E R â0â= no error
D
â1â= error
Command not legal for the current B
state
21 CARD_ECC_FAILE E X â0â= success
D
â1â= failure
Card internal ECC was applied C
but the correction of data is failed.
20 CC_ERROR
E R X â0â= no error
Internal card controller error
C
â1â= error
19 ERROR
E R X â0â= no error
â1â= error
A general or an unknown error C
occurred during the operation.
18 UNDERRUN
E X â0â= no error
â1â= error
The card could not sustain data C
transfer in stream read mode.
17 OVERRUN
E X â0â= no error
â1â= error
The card could not sustain data C
programming in stream write
mode.
42
|
▷ |