FH41-50S-0.5SH Datasheet, PDF (9/9 Pages) Hirose Electric – 0.5mm pitch, 2.5mm above the board,high speed transmission connector for shielded FFC

FH41 Series●0.5mm pitch, 2.5mm above the board,high speed transmission connector for shielded FFC
■Precautions (mating/un-mating FFC with the retention tabs)
Operation
Precautions
1.How to insert
Insert the cable into the interspace between the mold walls
( ) at both ends of entrance where the connector is
inserted and the guide walls ( ) at both ends of
interior connector so the cable tabs are properly located.
❷ Avoid “ride on”
Avoid insertion so the cables ride on any guide. Be
sure NOT to close the actuator as the cables ride on
any guide. It may cause conduction failure.
Ride on a left guide
Ride on a right guide
2.Precautions when mating /un-mating
❶ Avoid insertion in diagonal direction.
Do not insert the cable in diagonal direction.
A part of the connector may touches the contacts
resulting in deformation of the contacts.
Correct insertion
Do not close the actuator as the cables ride on.
Insert the cable straight into the connector and hook
the cable tabs with the guide.
After insertion, slightly pull the cables to make sure
the cable tabs are firmly secured. No removal of the
cable means correct insertion.
① Insert the cable straight
and obliquely from
above.
② Slightly pull the cable
to make sure the tabs
are firmly secured.
In the event it is locked as the cables ride on a guide,
absolutely avoid moving the cable. In this case, open
the actuator and re-insert the cable as instructed in “
1.How to insert”
Do not move the cables back and forth and around as
the cables ride on the guide when the actuator is closed.
③ Close the actuator.
9