FH41-50S-0.5SH Datasheet, PDF (8/9 Pages) Hirose Electric – 0.5mm pitch, 2.5mm above the board,high speed transmission connector for shielded FFC

FH41 Series●0.5mm pitch, 2.5mm above the board,high speed transmission connector for shielded FFC
■Operation and Precautions
Operation
1.FFC insertion procedure.
Connector installed on the board.
❶ Lift up the actuator. Use thumb or index finger
Precautions
❶ Do not force the actuator to open beyond its fully open
position. Do not use any type of tool to open the actuator.
110°
❷ Fully insert the FFC in the connector parallel to
mounting surface, with the exposed conductive traces
facing down.
❷ Do not forcefully bend the FFC upward. Consult FFC
manufacturer for the
recommended bend radiuses.
❸ Rotate down the actuator until firmly closed. It is
❸ For connectors with multiple contacts, such as 80 pos.
critical that the inserted FFC is not moved and remains rotate down the actuator pushing at both ends.
fully inserted.
2.FFC removal
Fully open the actuator.
Carefully withdraw the FFC exercising caution not to
deform or damage it.
❹ Load to FFC
Be very careful not to apply any force to the connector
directly after inserting FFC.
Otherwise, the connector may become unlocked or
the FFC may break.
In particular, design the FFC layout with care not to
bend it sharply upward in a vertial direction near the
insertion opening.
Fix the FFC when loads are applied to it continuously.
8