FH39-25S-0.3SHW Datasheet, PDF (11/11 Pages) Hirose Electric – 0.3 mm Pitch, 1.2 mm above the board, Top and bottom Contact, Back-Flip actuator

FH39 Seriesq0.3 mm Pitch, 1.2 mm above the board, Top and bottom Contact, Back-Flip actuator Flexible Printed Circuit ZIF Connectors
Precautions when mounting connectors on the PCB
xHandling before mounting on PCB
Insertion of the FPC or operation of the actuator prior to mounting on the PCB is NOT RECOMMENDED.
xPC board warpage
Minimize the warpage as much as possible. The connector is straight within 0.1 mm max. Make sure that the
mounting area flatness can accept the connector terminals without causing any failure of the solder joints.
xForces on the board
xWhen braking the large PC board into individual boards exercise care NOT to damage the
installed connectors.
xWhen attaching the boards or other components with the screws make sure that any stresses will
NOT cause board deflections affecting the mounting areas of the connector.
Connector
PCB
Other precautions
xWhen hand soldering:
Do not perform hand soldering with the FPC inserted in the connector.
• Do not apply excessive heat or touch the soldering iron anywhere other than the connector leads.
• Do not use excessive amount of solder or flux compounds.
Operation of the actuator or contacts may be affected by excessive amounts of solder or flux compounds.
11