PIDP-SS Datasheet, PDF (6/6 Pages) Gamewell-FCI by Honeywell – Monitor Modules with SmartScan

• Connect modules to listed compatible control panels only.
• Terminal wiring must be power limited.
• DO NOT MIX fire alarm initiating, supervisory, or security devices on the same circuit.
• DO NOT LOOP wire under terminals. Break wire run to provide supervision of connections.
• Detectors must be UL listed compatible with module.
• Install detectors per manufacturers’ installation instructions.
• Power to the interface module must be externally switched to reset the detectors. An
RCE-SS relay control module can be used to switch power from a standard power supply.
WIRING
DIAGRAMS
THIS PAGE:
CZI-SS
Fig. 6 CZI-SS: Interface two-wire conventional detectors, NFPA Style B.
6720wir5.wmf
Fig. 7 CZI-SS: Interface two-wire conventional detectors, NFPA Style D.
6720wir6.wmf
Gamewell-FCI
12 Clintonville Road
Northford, CT 06472-1610
Phone: [phone]
Fax: [phone]
www.gamewell-fci.com
A Honeywell Company
© 2006 Gamewell-FCI
Specifications and wiring information are provided for information only and are believed
to be accurate. Gamewell-FCI assumes no responsibility for their use.
Data and design are subject to change without notice. Installation and wiring instructions
shipped with the product shall always be used for actual installation. For more
information, contact Gamewell-FCI.
Page 6 of 6
PIDP-SS, PID-SS, CZI-SS, DPID-SS CS-2465 09/01/06