MB86292 Datasheet, PDF (11/25 Pages) Fujitsu Component Limited. – Graphics Display Controller

MB86292
s ABSOLUTE MAXIMUM RATINGS
Parameter
Rating
Symbol
Unit
Min
Max
Power supply voltage
Input voltage
Output current
VDDL*
VDDH
VI
IO
− 0.5
− 0.5
− 0.5
− 13
3.0
V
4.0
VDDH + 0.5 ( < 4.0)
V
+ 13
mA
Power pin current
Ambient storage temperature
IPOW
Tstg
60
− 55
60
mA
+ 125
°C
* : The PLL power supply is included.
WARNING: Semiconductor devices can be permanently damaged by application of stress (voltage, current,
temperature, etc.) in excess of absolute maximum ratings. Do not exceed these ratings.
s RECOMMENDED OPERATING CONDITIONS
Parameter
Power supply voltage
Input voltage (“H” level)
Input voltage (“L” level)
Ambient operating temperature
* : The PLL power supply is included.
Symbol
VDDL*
VDDH
VIH
VIL
TA
Min
2.3
3.0
2.0
− 0.3
− 40
Value
Typ
2.5
3.3



Max
2.7
3.6
VDDH + 0.3
+ 0.8
+ 85
Unit
V
V
V
°C
Notes : • The VDDL and VDDH power supplies can be turned on or off in either order.
Note, however, that the VDDH voltage must not be applied alone continuously for several seconds.
• Do not input the HSYNC, VSYNC, or EO signal with the power-supply voltage not applied. (See “Input
voltage” in “s ABSOLUTE MAXIMUM RATINGS”.)
• After turning the power on, input a pulse remaining at low level for at least 500 ns to the S pin. Then, set
the S pin to high level and input the RESET signal held at low level for at least 300 µs.
WARNING: The recommended operating conditions are required in order to ensure the normal operation of the
semiconductor device. All of the device’s electrical characteristics are warranted when the device is
operated within these ranges.
Always use semiconductor devices within their recommended operating condition ranges. Operation
outside these ranges may adversely affect reliability and could result in device failure.
No warranty is made with respect to uses, operating conditions, or combinations not represented on
the data sheet. Users considering application outside the listed conditions are advised to contact their
FUJITSU representatives beforehand.
11