MB15F72UL Datasheet, PDF (11/27 Pages) Fujitsu Component Limited. – Dual Serial Input PLL Frequency Synthesizer

MB15F72UL
3. Power Saving Mode (Intermittent Mode Control Circuit)
Status
PSIF/PSRF pins
Normal mode
H
Power saving mode
L
The intermittent mode control circuit reduces the PLL power consumption.
By setting the PS pins low, the device enters into the power saving mode, reducing the current consumption.
See the Electrical Characteristics chart for the specific value.
The phase detector output, Do, becomes high impedance.
For the dual PLL, the lock detector, LD, is as shown in the LD Output Logic table.
Setting the PS pins high, releases the power saving mode, and the device works normally.
The intermittent mode control circuit also ensures a smooth startup when the device returns to normal operation.
When the PLL is returned to normal operation, the phase comparator output signal is unpredictable. This is
because of the unknown relationship between the comparison frequency (fp) and the reference frequency (fr)
which can cause a major change in the comparator output, resulting in a VCO frequency jump and an increase
in lockup time.
To prevent a major VCO frequency jump, the intermittent mode control circuit limits the magnitude of the error
signal from the phase detector when it returns to normal operation.
Notes • When power (VCC) is first applied, the device must be in standby mode, PSIF = PSRF = Low, for at least 1 µs.
• PS pins must be set at “L” at Power-ON.
VCC
Clock
Data
LE
PSIF
PSRF
OFF
ON
tV 1 s
(1)
(2)
tPS > 100 ns
(3)
(1) PSIF = PSRF = “L” (power saving mode) at Power-ON
(2) Set serial data at least 1 µs after the power supply becomes stable (VCC ≥ 2.2 V) .
(3) Release power saving mode (PSIF, PSRF : “L” → “H”) at least 100 ns after setting serial
data.
11