MC9RS08KA2_08 Datasheet, PDF (91/136 Pages) Freescale Semiconductor, Inc – RS08 Microcontrollers

11.1.3 Block Diagram
The block diagram for the modulo timer module is shown Figure 11-2.
Modulo Timer (RS08MTIMV1)
BUSCLK
XCLK
TCLK
SYNC
CLOCK
SOURCE
SELECT
PRESCALE AND
SELECT DIVIDE
BY
8-BIT COUNTER
TRST
(MTIMCNT)
TSTP
MTIM
CLKS
PS
INTERRUPT
REQUEST
TOF
TOIE
8-BIT COMPARATOR
8-BIT MODULO
(MTIMMOD)
Figure 11-2. Modulo Timer (MTIM) Block Diagram
11.2 External Signal Description
The MTIM includes one external signal, TCLK, used to input an external clock when selected as the
MTIM clock source. The signal properties of TCLK are shown in Table 11-1.
Table 11-1. Signal Properties
Signal
Function
I/O
TCLK
External clock source input into MTIM
I
The TCLK input must be synchronized by the bus clock. Also, variations in duty cycle and clock jitter
must be accommodated. Therefore, the TCLK signal must be limited to one-fourth of the bus frequency.
The TCLK pin can be muxed with a general-purpose port pin. See the Pins and Connections chapter for
the pin location and priority of this function.
11.3 Register Definition
Each MTIM includes four registers, which are summarized in Table 11-2:
• An 8-bit status and control register
• An 8-bit clock configuration register
• An 8-bit counter register
• An 8-bit modulo register
Refer to the direct-page register summary in the memory section of this data sheet for the absolute address
assignments for all MTIM registers. This section refers to registers and control bits only by their names.
MC9RS08KA2 Series Data Sheet, Rev. 4
Freescale Semiconductor
91