908E624 Datasheet, PDF (7/40 Pages) Freescale Semiconductor, Inc – Integrated Triple High-Side Switch with Embedded MCU and LIN Serial Communication for Relay Drivers

ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
STATIC ELECTRICAL CHARACTERISTICS
Table 3. Static Electrical Characteristics
All characteristics are for the analog chip only. Refer to the 68HC908EY16 data sheet for characteristics of the microcontroller
chip. Characteristics noted under conditions 9.0 V ≤ V_SUP ≤ 16 V, - 40°C ≤ T_J ≤ 125°C unless otherwise noted. Typical values
noted reflect the approximate parameter mean at T_A = 25°C under nominal conditions unless otherwise noted.
Characteristic
Symbol
Min
Typ
Max
Unit
SUPPLY VOLTAGE RANGE
Nominal Operating Voltage
Functional Operating Voltage ⁽⁵⁾
V_SUP
5.5
—
18
V
V_SUPOP
—
—
27
V
SUPPLY CURRENT RANGE
Normal Mode ⁽⁶⁾
V_SUP = 13.5 V, Analog Chip in Normal Mode, MCU Operating Using
Internal Oscillator at 32 MHz (8.0 MHz Bus Frequency), SPI, ESCI, ADC
Enabled
Stop Mode ^{(6), (7)}
I_RUN
—
20
—
mA
V_SUP = 13.5 V, LIN in recessive state
Sleep Mode ^{(6), (7)}
I_STOP
—
60
75
µA
V_SUP = 13.5 V, LIN in recessive state
I_SLEEP
—
35
45
µA
DIGITAL INTERFACE RATINGS (ANALOG DIE)
Output Terminal RST_A
Low-State Output Voltage (I_OUT = - 1.5 mA)
High-State Output Current (V_OUT > 3.5 V)
Pulldown Current Limitation
Output Terminal IRQ_A
Low-State Output Voltage (I_OUT = - 1.5 mA)
High-State Output Voltage (I_OUT = 250 µA)
V_OL
—
—
0.4
V
I_OH
—
250
—
µA
I_{OL_MAX}
-1.5
—
-8.0
mA
V
V_OL
—
—
0.4
V_OH
3.85
—
—
Output Terminal RXD
Low-State Output Voltage (I_OUT = - 1.5 mA)
High-State Output Voltage (I_OUT = 250 µA)
Capacitance ⁽⁸⁾
V_OL
—
—
0.4
V
V_OH
3.85
—
—
V
C_IN
—
4.0
—
pF
Input Terminal PWMIN
Input Logic Low Voltage
Input Logic High Voltage
Input Current
Capacitance ⁽⁸⁾
V_IL
—
—
1.5
V
V_IH
3.5
—
—
V
I_IN
-10
—
10
µA
C_IN
—
4.0
—
pF
Terminal TXD, SS – Pullup Current
I_PU
—
40
—
µA
Notes
5. Device is fully functional. All functions are operating. Overtemperature may occur.
6. Total current (I_VSUP1 + I_VSUP2) measured at GND terminal.
7. Stop and Sleep mode current will increase if V_SUP exceeds 15 V.
8. This parameter is guaranteed by process monitoring but is not production tested.
Analog Integrated Circuit Device Data
Freescale Semiconductor
908E624
7