56F8365 Datasheet, PDF (30/172 Pages) Freescale Semiconductor, Inc – 16-bit Digital Signal Controllers

Signal
Name
FAULTA0
FAULTA1
FAULTA2
FAULTA3
PWMB0
PWMB1
PWMB2
PWMB3
PWMB4
PWMB5
ISB0
(GPIOD10)
ISB1
(GPIOD11)
ISB2
(GPIOD12)
FAULTB0
FAULTB1
FAULTB2
FAULTB3
ANA0
ANA1
ANA2
ANA3
Table 2-2 Signal and Package Information for the 128-Pin LQFP
Pin No.
Type
State
During
Reset
Signal Description
67
Schmitt
Input,
FAULTA0 - 2 — These three fault input pins are used for
Input
pull-up disabling selected PWMA outputs in cases where fault conditions
68
enabled originate off-chip.
69
To deactivate the internal pull-up resistor, set the PWMA0 bit in
the SIM_PUDR register. See Part 6.5.6 for details.
70
Schmitt
Input,
FAULTA3 — This fault input pin is used for disabling selected
Input
pull-up PWMA outputs in cases where fault conditions originate off-chip.
enabled
To deactivate the internal pull-up resistor, set the PWMA1 bit in
the SIM_PUDR register. See Part 6.5.6 for details.
32
Output
In reset, PWMB0 - 5 — Six PWMB output pins.
output is
33
disabled,
pull-up is
34
enabled
37
38
39
48
Schmitt
Input,
ISB0 - 2 — These three input current status pins are used for
Input
pull-up top/bottom pulse width correction in complementary channel
enabled operation for PWMB.
Schmitt
Input/
50
Output
Port D GPIO — These GPIO pins can be individually
programmed as input or output pins.
At reset, these pins default to ISA functionality.
51
Deactivate pull-up by setting the approproate bit of the
GPIOD_PUR register. See Part 6.5.6 for details.
54
Schmitt
Input,
FAULTB0 - 3 — These four fault input pins are used for disabling
Input
pull-up selected PWMB outputs in cases where fault conditions originate
55
enabled off-chip.
56
To deactivate the internal pull-up resistor, set the PWMB bit in the
SIM_PUDR register. See Part 6.5.6 for details.
57
80
Input
Analog ANA0 - 3 — Analog inputs to ADC A, channel 0
Input
81
82
83
56F8365 Technical Data, Rev. 6.0
30
Freescale Semiconductor
Preliminary