MCF5282CVM66 Datasheet, PDF (277/766 Pages) Freescale Semiconductor, Inc – MCF5282 and MCF5216 ColdFire® Microcontroller User’s Manual

Synchronous DRAM Controller Module
15
14
13
12
11
10
9
8
0
Field
—
NAM COC IS
RTIM
RC
Reset
Uninitialized
R/W
R/W
Addr
IPSBAR + 0x040
Figure 15-2. DRAM Control Register (DCR)
Table 15-4 describes DCR fields.
Table 15-4. DCR Field Descriptions
Bits Name
Description
15-14 — Reserved, should be cleared.
13 NAM No address multiplexing. Some implementations require external multiplexing. For example, when
linear addressing is required, the SDRAM should not multiplex addresses on SDRAM accesses.
0 The SDRAM controller multiplexes the external address bus to provide column addresses.
1 The SDRAM controller does not multiplex the external address bus to provide column addresses.
12 COC Command on SDRAM clock enable (SCKE). Implementations that use external multiplexing (NAM = 1)
must support command information to be multiplexed onto the SDRAM address bus.
0 SCKE functions as a clock enable; self-refresh is initiated by the SDRAM controller through
DCR[IS].
1 SCKE drives command information. Because SCKE is not a clock enable, self-refresh cannot be
used (setting DCR[IS]). Thus, external logic must be used if this functionality is desired. External
multiplexing is also responsible for putting the command information on the proper address bit.
11 IS Initiate self-refresh command.
0 Take no action or issue a SELFX command to exit self refresh.
1 If DCR[COC] = 0, the SDRAM controller sends a SELF command to both SDRAM blocks to put them
in low-power, self-refresh state where they remain until IS is cleared. When IS is cleared, the
controller sends a SELFX command for the SDRAMs to exit self-refresh. The refresh counter is
suspended while the SDRAMs are in self-refresh; the SDRAM controls the refresh period.
10–9
RTIM
Refresh timing. Determines the timing operation of auto-refresh in the SDRAM controller. Specifically,
it determines the number of bus clocks inserted between a REF command and the next possible ACTV
command. This same timing is used for both memory blocks controlled by the SDRAM controller. This
corresponds to t_RC in the SDRAM specifications.
00 3 clocks
01 6 clocks
1x 9 clocks
8–0 RC Refresh count. Controls refresh frequency. The number of bus clocks between refresh cycles is
(RC + 1) x 16. Refresh can range from 16–8192 bus clocks to accommodate both standard and
low-power SDRAMs with bus clock operation from less than 2 MHz to greater than 50 MHz.
The following example calculates RC for an auto-refresh period for 4096 rows to receive 64 ms of
refresh every 15.625 µs for each row (1031 bus clocks at 66 MHz). This operation is the same as in
asynchronous mode.
# of bus clocks = 1031 = (RC field + 1) x 16
RC = (1031 bus clocks/16) -1 = 63.44, which rounds to 63; therefore, RC = 0x3F.
Freescale Semiconductor
MCF5282 and MCF5216 ColdFire Microcontroller User’s Manual, Rev. 3
15-5