MC908MR16CBE Datasheet, PDF (235/282 Pages) Freescale Semiconductor, Inc – The following revision history table summarizes changes contained in this document.

Chapter 17
Timer Interface B (TIMB)
17.1 Introduction
This section describes the timer interface module B (TIMB). The TIMB is a 2-channel timer that provides:
• Timing reference with input capture
• Output compare
• Pulse-width modulation functions
Figure 17-2 is a block diagram of the TIMB.
NOTE
The TIMB module is not available in the 56-pin shrink dual in-line package
(SDIP).
17.2 Features
Features of the TIMB include:
• Two input capture/output compare channels:
– Rising-edge, falling-edge, or any-edge input capture trigger
– Set, clear, or toggle output compare action
• Buffered and unbuffered pulse-width modulation (PWM) signal generation
• Programmable TIMB clock input:
– 7-frequency internal bus clock prescaler selection
– External TIMB clock input (4-MHz maximum frequency)
• Free-running or modulo up-count operation
• Toggle any channel pin on overflow
• TIMB counter stop and reset bits
17.3 Functional Description
Figure 17-2 shows the TIMB structure. The central component of the TIMB is the 16-bit TIMB counter that
can operate as a free-running counter or a modulo up-counter. The TIMB counter provides the timing
reference for the input capture and output compare functions. The TIMB counter modulo registers,
TBMODH–TBMODL, control the modulo value of the TIMB counter. Software can read the TIMB counter
value at any time without affecting the counting sequence.
The two TIMB channels are programmable independently as input capture or output compare channels.
NOTE
The TIMB module is not available in the 56-pin SDIP.
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
Freescale Semiconductor
235