FO600 Datasheet, PDF (52/57 Pages) Extech Instruments Corporation. – FiberMeter Optical Power Meter

UNIT 5
Appendices
Cleaning and Care Instructions
1 - Do NOT drop any piece of sensitive scientific equipment. Damage may occur to the case or electronic
components on the circuit board may become dislodged, and inaccuracy may occur.
2 - Keep the meter in an enclosed case when not in use. This will help protect the meter from the elements
and accidental droppage.
3 - Store the meter in a cool dry area when not in use in order to keep the meter in top working condition.
4 - We recommend not removing the universal connector as it is not necessary for cleaning. Its parts are very
fragile, small, and easy to lose.
5 - Always remember to replace the rubber cap on the connector. This will keep out dust and dirt when the
meter is not in use.
6 - Use only 99% or better Isopropyl alcohol when cleaning the detector. Any less than 99% contains too
much water and will begin to corrode the components. 99% Isopropyl alcohol is very flammable, so additional
care must be taken when cleaning the detector. 99% Isopropyl alcohol can be purchased at your local drug
store.
7 - Whenever possible, use specially designed 2.5mm cleaning sticks to clean the detector. These do not
require alcohol and do not damage the insides of the connector. Do not used sticks or swabs of any other type
because they may damage the zirconium ferrule or the coating of the detector inside the connector, or may
leave behind dust or fibers that will add loss to the fiber reading.
8 - The detector port should be cleaned at the beginning and end of each testing day to keep connector loss
during testing at a minimum.
9 - When cleaning the meter itself, do not use any household cleaner that contains ammonia as this will
damage any plastic it comes in contact with.
10 - The case is splash-proof, so it is not necessary to clean the inside of the meter.
11 - Only use lint-free cloths when cleaning the display. Anything else may scratch the plastic.
5-5