FO600 Datasheet, PDF (32/57 Pages) Extech Instruments Corporation. – FiberMeter Optical Power Meter

UNIT 3
CERTIFICATION METER
CERTIFICATION METER - Cabling Standard Certification Test; cont.
5)
Edit the DATE. Use F1 to backspace, then enter the link name using
the alpha-numeric keys. Press DONE when finished entering the date.
NOTE: It is of vital importance to change the date using the format MM-DD-YY. If
the date is entered incorrectly, or not entered at all, Extech Reporter will display
an incorrect date on the software and reports.
DATE:
[01/01/01]
_____________________
<--- SHIFT --->
CONFIGURE LINK PROPERTIES AND SET REFERENCE
6)
Use F1 to scroll through the list of fiber standards. Once the chosen
standard is highlighted, press _F2 to select.
NOTE: users may create their own standards. See page 3-15 for instructions.
7)
Use F1 to scroll through the list of fiber types. Once the fiber type that
matches the cable under test is highlighted, press F2 to select.
FIBER STANDARDS
USER DEFINED #1
USER DEFINED #2
TIA-568B 3/CAN-T529
ISO/IEC 11801
_____________________
NEXT SELECT
FIBER TYPES
62 5um MultiMode
50 0um Multimode
INDOOR SingleMode
OUTDOOR SingleMode
_____________________
NEXT SELECT
THE METER WILL SKIP TO STEP 10 IF THE OPTIONAL LIGHT SOURCE IS NOT INSTALLED.
8)
Connect the detector port and light source port to two fibers in the link via
patch cords. On the other end of the link, connect the same two fibers with a
single patch cord, thus creating a loop. When the patch cords are connected,
press F1 to run the LENGTH TEST.
^ CONNECT ^
FIBER A
FIBER B
(FIBER PAIR REQUIRED)
PATCH FIBER A TO
FIBER B AT THE FAR
END OF THE LINK.
_____________________
DONE
^ CONNECT ^
FIBER A
FIBER B
(FIBER PAIR REQUIRED)
PATCH FIBER A TO
FIBER B AT THE FAR
END OF THE LINK.
_____________________
DONE
Symbolic
Fiber
Link
9)
After the length test is complete, the fiber length will be displayed in
meters. Press F2 to continue.
NOTE: if CANNOT DETERMINE LENGTH appears on the display, double-check
to make sure that the fiber link is connected as shown above. To test the
equipment ports, take a single patch cord and connect it between the two ports,
then press F1 to re-test. If the fiber length comes up as 00003 +/-3 meters, then
the problem rests in the fiber link itself.
FIBER LENGTH
01000 +/-3 METERS
1550nm Index(n)=1 490
_____________________
TEST DONE INDEX
3-11