XR16V698 Datasheet, PDF (7/58 Pages) Exar Corporation – 2.25V TO 3.6V HIGH PERFORMANCE OCTAL UART WITH 32-BYTE FIFO

XR16V698
REV. 1.0.3
2.25V TO 3.6V HIGH PERFORMANCE OCTAL UART WITH 32-BYTE FIFO
1.0 DESCRIPTION
The XR16V698 (698) integrates the functions of 8 enhanced 16550 UARTs, a general purpose 16-bit timer/
counter and an on-chip oscillator. The device configuration registers include a set of four consecutive interrupt
source registers that provides interrupt-status for all 8 UARTs, timer/counter and a sleep wake up indicator.
Each UART channel has its own 16550 UART compatible configuration register set for individual channel
control, status, and data transfer. Additionally, each UART channel has 32-byte of transmit and receive FIFOs,
automatic RTS/CTS or DTR/DSR hardware flow control with hysteresis control, automatic Xon/Xoff and special
character software flow control, programmable transmit and receive FIFO trigger levels, infrared encoder and
decoder (IrDA ver. 1.0), programmable baud rate generator with a prescaler of divide by 1 or 4, and data rate
up to 15Mbps with 4X sampling clock or 7.5Mbps with 8X sampling clock at 3.3V and 10Mbps with 4X sampling
clock or 5Mbps with 8X sampling clock at 2.5V. The XR16V598 is a 2.25-3.6V device with 5 volt tolerant inputs
(except XTAL1).
2.0 FUNCTIONAL DESCRIPTIONS
2.1 Device Reset
2.1.1 Hardware Reset
The RST# input resets the internal registers and the serial interface outputs in all 8 channels to their default
state (see Table 18). A LOW pulse of longer than 40 ns duration will be required to activate the reset function
in the device.
2.1.2 Software Reset
The internal registers of each UART can be reset by writing to the RESET register in the Device Configuration
Registers. For more details, see the RESET register description on page 29.
2.2 UART Channel Selection
A LOW on the chip select pin, CS#, allows the user to select one of the UART channels to configure, send
transmit data and/or unload receive data to/from the UART. When address line A7 = 0, address lines A6:A4
are used to select one of the eight channels. See Table 1 below for UART channel selection.
TABLE 1: UART CHANNEL SELECTION
A7
A6
A5
A4
FUNCTION
0
0
0
0
Channel 0 Selected
0
0
0
1
Channel 1 Selected
0
0
1
0
Channel 2 Selected
0
0
1
1
Channel 3 Selected
0
1
0
0
Channel 4 Selected
0
1
0
1
Channel 5 Selected
0
1
1
0
Channel 6 Selected
0
1
1
1
Channel 7 Selected
2.3 Simultaneous Write to All Channels
During a write cycle, the setting of the Device Configuration register REGB (See Table 8) bit-0 to a logic 1 will
override the channel selection of address A6:A4 and allow a simultaneous write to all 8 UART channels when
any channel is written to. This functional capability allow the registers in all 8 UART channels to be modified
concurrently, saving individual channel initialization time. Caution should be considered, however, when using
this capability. Any in-process serial data transfer may be disrupted by changing an active channel’s mode.
7