XR21B1420IL28-0A Datasheet, PDF (41/60 Pages) Exar Corporation – Enhanced 1-Ch Full-Speed USB UART

XR21B1420
CDC_ACM_FLOW (0x008) - Read/Write OTP
Bit
15:4
3
2:0
Default
Description
0
Reserved
These bits are reserved and should be written as ‘0’.
0
UART Half-Duplex Mode
0: Normal (full-duplex) mode. The UART can transmit and receive data at the same time.
1: UART Half-Duplex Mode. In half-duplex mode, any data on the RX pin is ignored when the UART is transmit-
ting data.
000
Mode
000: Mode 0. No flow control, no address matching.
001: Mode 1. HW flow control enabled. Auto RTS/CTS or DTR/DSR must be selected by GPIO_MODE.
010: Mode 2. SW flow control enabled.
011: Mode 3. Multidrop mode - RX only after address match, TX independent. (Typically used with GPIO_-
MODE 3).
100: Mode 4. Multidrop mode - RX/TX only after address match. (Typically used with GPIO_MODE 4).
101 to 111: Reserved
CDC_ACM_MODE_LSB (0x009) - Read/Write OTP
Bit
7
6:5
4
3
Default
Description
0
Clock Enable
0: GPIO6 is used for general purpose I/O
1: GPIO6 is used to output a clock.
0
Auto RS-485 Half-Duplex Select
00: GPIO. GPIO7/RS485 is used for general purpose I/O
01: RS485_EN_ACT. GPIO7/RS485 is used for auto RS-485 half-duplex enable. Asserted whenever the UART
is transmitting
10: RS485_EN_FLOW. GPIO7/RS485 is used for auto RS-485 half-duplex enable. Asserted for the duration of
the address match
11: RESERVED. Reserved value, do not use
0
Auto RS-485 Half-Duplex Pin
0: GPIO5/RTS#/RS485 function is selected by GPIO_MODE[2:0]. GPIO7/RS485 function is GPIO.
1: GPIO7/RS485 function is selected by GPIO_MODE[6:5]. GPIO5/RTS#/RS485 function must be any function
other than that selected for GPIO7/RS485.
0
Auto RS-485 Half-Duplex Polarity
0: GPIO5/RTS#/RS485 function is selected by GPIO_MODE[2:0]. GPIO7/RS485 function is GPIO.
1: GPIO7/RS485 function is selected by GPIO_MODE[6:5]. GPIO5/RTS#/RS485 function must be any function
other than that selected for GPIO7/RS485.
© 2014 Exar Corporation
41 / 60
exar.com/XR21B1420
Rev 1A