XR16L570 Datasheet, PDF (4/46 Pages) Exar Corporation – SMALLEST 1.62V TO 5.5V UART WITH 16-BYTE FIFO AND POWERSAVE

XR16L570
SMALLEST 1.62V TO 5.5V UART WITH 16-BYTE FIFO AND POWERSAVE
xr
REV. 1.0.0
Pin Descriptions
24-QFN 32-QFN
NAME
TYPE
PIN# PIN#
DESCRIPTION
CD#
-
26
I _{UART Carrier-Detect (active low) or general purpose input. This input should be con-}
nected to VCC when not used. This input has no effect on the UART. This pin is not
available in the 24-QFN package.
RI#
-
27
I _{UART Ring-Indicator (active low) or general purpose input. This input should be con-}
nected to VCC when not used. This input has no effect on the UART. This pin is not
available in the 24-QFN package.
ANCILLARY SIGNALS
XTAL1 8
10
(CLK)
XTAL2
-
11
PwrSave 7
-
RESET 17
23
VCC
GND
GND
19
28
10
13
Center Center
Pad Pad
I _{Crystal or external clock input. This input is not 5V tolerant.}
O _{Crystal or buffered clock output. This output may be use to drive a clock buffer which}
can drive other device(s). This pin is not available in the 24-QFN package.
I _{Power-Save (active high). This feature isolates the L570’s data bus interface from}
the host preventing other bus activities that cause higher power drain during sleep
mode. See Sleep Mode with Auto Wake-up and Power-Save Feature section for
details. This pin is not available in the 28-QFN package.
I _{This input is the active high RESET signal.}
A 40 ns minimum active pulse on this pin will reset the internal registers and all out-
puts of the UART. The UART transmitter output will be held at logic 1, the receiver
input will be ignored and outputs are reset during reset period (see UART Reset Con-
ditions).
Pwr _{1.62V to 5.5V power supply. All input pins, except CLK, are 5V tolerant.}
Pwr _{Power supply common, ground.}
Pwr _{The center pad on the backside of the QFN packages is metallic and should be con-}
nected to GND on the PCB. The thermal pad size on the PCB should be the approxi-
mate size of this center pad and should be solder mask defined. The solder mask
opening should be at least 0.0025" inwards from the edge of the PCB thermal pad.
NOTE: Pin type: I=Input, O=Output, I/O= Input/output, OD=Output Open Drain.
4