XR17D152IM-F Datasheet, PDF (33/68 Pages) Exar Corporation – UNIVERSAL (3.3V AND 5V) PCI BUS DUAL UART

áç
REV. 1.2.0
XR17D152
UNIVERSAL (3.3V AND 5V) PCI BUS DUAL UART
5.6 Internal Loopback
Each UART channel provides an internal loopback capability for system diagnostic. The internal loopback
mode is enabled by setting MCR register bit-4 to logic 1. All regular UART functions operate normally.
Figure 18 shows how the modem port signals are re-configured. Transmit data from the transmit shift register
output is internally routed to the receive shift register input allowing the system to receive the same data that it
was sending. The TX, RTS# and DTR# pins are held HIGH (idle or de-asserted state), and the CTS#, DSR#
CD# and RI# inputs are ignored.
FIGURE 18. INTERNAL LOOP BACK FUNCTION IN EACH UART CHANNEL
VCC
Transmit Shift
Register
MCR bit-4=1
Receive Shift
Register
VCC
RTS#
CTS#
DTR#
VCC
DSR#
RI#
CD#
OP1#
OP2#
TX [1:0]
RX [1:0]
RTS# [1:0]
CTS# [1:0]
DTR# [1:0]
DSR# [1:0]
RI# [1:0]
CD# [1:0]
5.7 UART CHANNEL CONFIGURATION REGISTERS AND ADDRESS DECODING.
The 2 sets of UART configuration registers are decoded using address lines A9 to A11 as shown below.
A11 A10
0
0
0
0
A9 ^{UART CHANNEL}
SELECTION
0
0
1
1
33