|
XRT71D00_01 Datasheet, PDF (1/26 Pages) Exar Corporation – E3/DS3/STS-1 JITTER ATTENUATOR | |||
|
áç
XRT71D00
SEPTEMBER 2001
GENERAL DESCRIPTION
The XRT71D00 is a single channel, single chip Jitter
Attenuator, that meets the Jitter transfer characteristic
requirements specified in the ETSI TBR-24, Bellcore
GR-499-CORE and GR-253-CORE standards.
In addition, the XRT71D00 also meets the Output Jit-
ter and Wander specifications described in the ANSI
T1.105.03b 1997, Bellcore GR-253-CORE and GR-
499-CORE standards.
FEATURES
⢠Meets E3/DS3/STS-1 jitter transfer requirements
⢠No external components required
⢠Compliant with the jitter transfer characteristic
requirements specified in ITU G.751, G.752, and
G.755 for E3 applications
FIGURE 1. BLOCK DIAGRAM OF THE XRT71D00
E3/DS3/STS-1 JITTER ATTENUATOR
REV. 1.2.0
⢠Meets jitter transfer characteristic requirement as
specified by ETSI TBR24 (for E3 applications).
⢠Meets the Output Jitter and Wander specifications
described in ANSI T1.105.03b, Bellcore GR-253-
CORE and Bellcore GR-499-CORE standards.
⢠Selectable buffer size of 16 and 32 bits
⢠Jitter attenuator can be disabled
⢠Available in a 32 pin TQFP package.
⢠Single 3.3V or 5.0V supply.
⢠Operates over - 400 C to 850 C temperature range.
APPLICATIONS
⢠E3/DS3 Access Equipment.
⢠DSLAMs
BWS
ICT
DJA
RClk
ClkES
RPOS
RNEG
Timing Control Block /
Phase locked Loop
Write Clock
Read Clock
16/32 Bit FIFO
MClk
RRClk
RRPOS
RRNEG
FL
HOST/HW
Reset
E3/DS3
Microprocessor Serial
Interface
CS SDI SDO SClk
Exar Corporation 48720 Kato Road, Fremont CA, 94538 ⢠(510) 668-7000 ⢠FAX (510) 668-7017 ⢠www.exar.com
|
▷ |