FX15SC-51S-0.5SV Datasheet, PDF (20/24 Pages) List of Unclassifed Manufacturers – 1mm Pitch Cable-to-Board Connectors supporting LVDS signal

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.
All non-RoH_FS _Xpr₁od₅uc_Sts_erh_ia_eve_sb_qee₁n_mdis_mcon_Pti_in_tu_ced_h, o_Cr _awi_bll _lb_ee_-d_ti_osc_-o_Bnt_oin_aue_rd_dso_Con_o._nPl_nea_es_ce _tc_ohe_rc_sk t_she_uppr_pod_ou_rc_tt_is_ns_gtat_Lus_Vo_Dn t_She_sH_iir_go_nse_aw_lebsite RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.
Precautions and recommendations
5. After soldering, check that no defect is found at soldered area.
Examples of correct soldered and defective soldered state are shown below.
Solder shortage
A
AA
solder bridge
B
BB
A
Correct soldering
B
Floating
[ Coutions for potting process ]
1. Protect the soldered area by UV cured resin (referred as "potting" hereafter), in order to prevent cable breakage during cabling and other troubles.
2. Apply 3033 manufactured by THREEBOND CO., LTD. or any equivalent product for potting.
Follow the instruction of potting manufacture's for the condition of UV exposure.
3. Refer to the following conditions the potting area.
Number of contacts
A
41
23.7
51
28.7
A
0
-3
1.25
0
-0.75
A
Enlarged view
4. Use extreme care for the handling after solding to the end potting process not to apply stress to the cable, otherwise, cable could be broken.
B292