M0516ZAN Datasheet, PDF (17/71 Pages) List of Unclassifed Manufacturers – ARM Cortex™-M0 32-BIT MICROCONTROLLER

NuMicro^™ M058/M0516 Data Sheet
Pin number
Alternate Function
Symbol
QFN33 LQFP48
1
2
Type^[1]
Description
6
8
P3.2 _INT0 STADC I/O INT1, T0, T1, WR , and RD .
T0: Timer0 external input
NC
9
P3.3
INT1
MCLK
I/O T1: Timer1 external input
The RXD/TXD pins are for UART0 function used.
7
10
P3.4
T0
SDA
I/O _{The SDA/SCL pins are for I}2_{C function used.}
MCLK: EBI clock output pin.
8
11
P3.5
T1
SCL
I/O
CKO: HCLK clock output
9
13
P3.6
WR
CKO
I/O The STADC pin is for ADC external trigger input.
NC
14
P3.7
RD
NC
24
P4.0 PWM0
NC
36
P4.1 PWM1
NC
48
P4.2 PWM2
NC
12
P4.3 PWM3
NC
28
P4.4
/CS
NC
29
P4.5
ALE
19
30
P4.6 ICE_CLK
20
31
P4.7 ICE_DAT
I/O
I/O
I/O
PORT4: Port 4 is an 8-bit four mode output pin and two
mode input. Its multifunction pins are for /CS, ALE,
I/O _{ICE_CLK and ICE_DAT.}
/CS for EBI (External Bus Interface) used.
I/O
ALE (Address Latch Enable) is used to enable the address
latch that separates the address from the data on Port 0
I/O _{and Port 2.}
The ICE_CLK/ICE_DAT pins are for JTAG-ICE function
I/O _used.
PWM0-3 can be used from P4.0-P4.3 when EBI is active.
I/O
I/O
Table 5-1 NuMicro™ M051 Series Pin Description
[1] I/O type description. I: input, O: output, I/O: quasi bi-direction, D: open-drain, P: power pins,
ST: Schmitt trigger.
- 17 -
Publication Release Date: May 30, 2011
Revision V2.00