W79E632A Datasheet, PDF (11/79 Pages) Winbond – 8-BIT MICROCONTROLLER

W79E632A/W79L632A
IE1: Interrupt 1 edge detect: Set by hardware when an edge/level is detected on INT1. This bit is
cleared by hardware when the service routine is vectored to only if the interrupt was edge
triggered. Otherwise it follows the pin.
IT1: Interrupt 1 type control: Set/cleared by software to specify falling edge/ low level triggered
external inputs.
IE0: Interrupt 0 edge detect: Set by hardware when an edge/level is detected on INT0 . This bit is
cleared by hardware when the service routine is vectored to only if the interrupt was edge
triggered. Otherwise it follows the pin.
IT0: Interrupt 0 type control: Set/cleared by software to specify falling edge/ low level triggered
external inputs.
Timer Mode Control
Bit:
7
6
5
4
3
2
1
0
GATE _{C / T} M1
M0 GATE _{C / T}
M1
M0
Mnemonic: TMOD
TIMER1
TIMER0
Address: 89h
GATE: Gating control: When this bit is set, Timer/counter x is enabled only while INTx pin is high and
TRx control bit is set. When cleared, Timer x is enabled whenever TRx control bit is set.
C / T : Timer or Counter Select: When cleared, the timer is incremented by internal clocks. When set
, the timer counts high-to-low edges of the Tx pin.
M1, M0: Mode Select bits:
M1 M0
00
01
10
11
Timer 0 LSB
MODE
Mode 0: 8-bits with 5-bit prescale.
Mode 1: 16-bits, no prescale.
Mode 2: 8-bits with auto-reload from THx
Mode 3: (Timer 0) TL0 is an 8-bit timer/counter controlled by the standard Timer 0
control bits. TH0 is a 8-bit timer only controlled by Timer 1 control bits. (Timer 1)
Timer/counter is stopped.
Bit:
7
6
5
4
3
2
1
0
TL0.7 TL0.6 TL0.5 TL0.4 TL0.3 TL0.2 TL0.1 TL0.0
Mnemonic: TL0
Address: 8Ah
TL0.7−0: Timer 0 LSB
Timer 1 LSB
Bit:
7
6
5
4
3
2
1
0
- 11 -
Publication Release Date: Nov. 11, 2009
Revision A10