C8051F340 Datasheet, PDF (73/282 Pages) List of Unclassifed Manufacturers – Full Speed USB Flash MCU Family

C8051F340/1/2/3/4/5/6/7
9. CIP-51 Microcontroller
The MCU system controller core is the CIP-51 microcontroller. The CIP-51 is fully compatible with the
MCS-51™ instruction set; standard 803x/805x assemblers and compilers can be used to develop soft-
ware. The MCU family has a superset of all the peripherals included with a standard 8051. Included are
four 16-bit counter/timers (see description in Section 21), an enhanced full-duplex UART (see description
in Section 18), an Enhanced SPI (see description in Section 20), 256 bytes of internal RAM, 128 byte
Special Function Register (SFR) address space (Section 9.2.6), and 25 Port I/O (see description in Sec-
tion 15). The CIP-51 also includes on-chip debug hardware (see description in Section 23), and interfaces
directly with the analog and digital subsystems providing a complete data acquisition or control-system
solution in a single integrated circuit.
The CIP-51 Microcontroller core implements the standard 8051 organization and peripherals as well as
additional custom peripherals and functions to extend its capability (see Figure 9.1 for a block diagram).
The CIP-51 includes the following features:
- Fully Compatible with MCS-51 Instruction
Set
- 0 to 48 MHz Clock Frequency
- 256 Bytes of Internal RAM
- 25 Port I/O
- Extended Interrupt Handler
- Reset Input
- Power Management Modes
- On-chip Debug Logic
- Program and Data Memory Security
DATA BUS
ACCUMULATOR
TMP1
TMP2
PSW
ALU
B REGISTER
STACK POINTER
SRAM
ADDRESS
REGISTER
SRAM
(256 X 8)
DATA BUS
BUFFER
D8
DATA POINTER
D8
PC INCREMENTER
SFR_ADDRESS
SFR
SFR_CONTROL
D8
BUS
SFR_WRITE_DATA
INTERFACE
SFR_READ_DATA
PROGRAM COUNTER (PC)
PRGM. ADDRESS REG.
RESET
CLOCK
CONTROL
LOGIC
PIPELINE
STOP
IDLE
POWER CONTROL
REGISTER
D8
D8
MEM_ADDRESS
MEM_CONTROL
MEMORY
A16
INTERFACE ^{MEM_WRITE_DATA}
MEM_READ_DATA
D8
INTERRUPT
INTERFACE
D8
SYSTEM_IRQs
EMULATION_IRQ
Figure 9.1. CIP-51 Block Diagram
Rev. 0.5
73