IC693MDL760 Datasheet, PDF (5/6 Pages) List of Unclassifed Manufacturers – Solenoid Valve Output Module

Solenoid Valve Output Module
5
GFK-1881A
Field Connectors
The following specifications are for the mating connectors (not supplied with the module) for the
module’s two faceplate connectors (“Pendent” and “DC Output”).
Pendent Connector (Supplied with Optional Pendent)
Item
Vendor
Part Number Note
Male Housing
AMP
87631-7
12-pin connector housing
Crimp Contacts (12
required)
AMP
1-87523-9
Female pins, rated for AWG 20-24
gauge wire
Crimping Tool
AMP
90202-2
DC Output Connector
Item
Male Housing
Crimp Contacts (10
required)
Crimping Tool
Vendor
AMP
AMP
AMP
Part Number Notes
87631-5
10-pin connector housing
1-87523-9
Female pins, rated for AWG 20-24
gauge wire
90202-2
Pneumatic Fitting Specifications and Installation Instructions
Module
Fitting
Number
per Module
Vendor
Part
Number
Notes
Front 11
Clippard 11752-2 10-32 threads, 1/16″ hose barb, 1/4″ hex. shoulder
Bottom 1
Clippard 11752-3 10-32 threads, 1/8″ hose barb, 1/4″ hex. shoulder
Due to limited room in the module’s packing container, it is necessary to ship the module with its fittings
removed. Use the following guidelines to install the fittings on the module:
• Place the provided gasket over the threaded end of the fitting and carefully push it over the threads
until it stops against the hexagonal shoulder.
• Carefully thread the fitting into the manifold by hand.
• Tighten the fitting to a maximum of 7 to 9 inch/pounds.
Caution
Overtightening may cause a fitting to crack or snap off, or could result in thread
damage. Limit tightening torque to 7 to 9 inch/pounds.