CM312 Datasheet, PDF (41/56 Pages) List of Unclassifed Manufacturers – Communications utilityModule

• boot DOS from a floppy
• login to the network server
• run netgen and select Netware Installation
• reboot from hard disk
To generate the 2.2 server from an existing Network Disk:
• Boot DOS from a floppy
• login to the network server
• Run install (when prompted to, select NE2000 driver)
• reboot from hard drive
Novell Netware 3.x/4.x
Use the install.nlm utility loaded from the server console, "load ...\install", to create an autoexec
file as shown below:
AUTOEXEC.NCF
file server name BIGKAHOONAS
ipx internal net 10
load c:\ne2000 PORT=360 INT=5
bind ipx to ne2000 net=1
mount all
Typing SERVER at the DOS prompt will load the server and our driver.
Be sure ne2000.lan is in the c:\ directory
Driver configurable options are:
IO BASE
May be set by including the following in the command line:
Port = xxx
;where xxx can be 300, 320, 340, 360
Be sure the board is set to the same I/O address, otherwise the driver won't find the board and the
message "Hardware Error - NE2000 Bank Select port failed to respond." will appear.
INTERRUPT NUMBER
May be set by including the following in the command line:
Int = x
;where x can be 2, 3, 4, 5, 10, 11, 12, 15
Defaults to EEPROM configuration if not present
NODE ADDRESS
The board has a unique IEEE address, but it may be overwritten by including the following in the
command line:
Node = xxxxxxxxxxxx
Where xxxxxxxxxxxx is a 12 digit hex number (non-multicast or broadcast)
CM312 Quad Serial utilityModule
31
RTD Embedded Technologies, Inc.