S1D13806 Datasheet, PDF (464/730 Pages) Epson Company – S1D13806 Embedded Memory Display Controller

Page 10
Epson Research and Development
Vancouver Design Center
Installation for CEPC Environment
Once the NK.BIN file is built, the CEPC environment can be started by booting either from a
floppy or hard drive configured with a Windows 9x operating system. The two methods are
described below.
1. To start CEPC after booting from a floppy drive:
a. Create a bootable floppy disk.
b. Edit CONFIG.SYS on the floppy disk to contain only the following line:
device=a:\himem.sys
c. Edit AUTOEXEC.BAT on the floppy disk to contain the following lines:
mode com1:9600,n,8,1
loadcepc /B:9600 /C:1 c:\nk.bin
d. Copy LOADCEPC.EXE and HIMEM.SYS to the bootable floppy disk. Search for
the loadCEPC utility in your Windows CE directories.
e. Copy NK.BIN to c:\.
f. Boot the system from the bootable floppy disk.
2. To start CEPC after booting from a hard drive:
a. Copy LOADCEPC.EXE to C:\. Search for the loadCEPC utility in your Windows
CE directories.
b. Edit CONFIG.SYS on the hard drive to contain only the following line:
device=c:\himem.sys
c. Edit AUTOEXEC.BAT on the hard drive to contain the following lines:
mode com1:9600,n,8,1
loadcepc /B:9600 /C:1 c:\nk.bin
d. Copy NK.BIN and HIMEM.SYS to c:\.
e. Boot the system.
S1D13806
X28B-E-001-05
Windows® CE 2.x Display Drivers
Issue Date: 01/05/22