EPC110 Datasheet, PDF (2/27 Pages) Espros Photonics corp – Fully integrated configurable light barrier driver & receiver

epc110
Absolute Maximum Ratings (Notes 1, 2)
Recommended Operating Conditions
Voltage at any pin except pin VDD
-0.3V to VN +0.3 V
Min. Max. Units
Power Supply Voltage at pin VDD
Programming Voltage at pin VDD
-0.3V to +5.5V
-0.3V to +8.0V
Operating supply voltage at VDD
Programming voltage at VDD
3.0
3.6
V
7.0
8.0
V
Power Supply Voltage at pin VDD33
-0.3V to +5.5V
Operating supply voltage at VDD33
3.0
3.6
V
Output current at any pin except pin LED
Power Consumption with maximum load
-6mA to +6mA
125 mW
Operating Temperature (TO)
-40°
+85°
C
Lead Temperature solder, 4 sec. (TL)
+260°C
Humidity (non-condensing)
+5
+95
%
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the device may occur. Recommended operating conditions
indicate conditions for which the device is intended to be functional, but do not guarantee specific performance limits. For guaranteed specific -
ations and test conditions, see Electrical Characteristics.
Note 2: This device is a highly sensitive CMOS ac current amplifier with an ESD rating of JEDEC HBM class 0 (<250V). Handling and
assembly of this device should only be done at ESD protected workstations.
Electrical Characteristics
3.0V < VN < 3.6V, -40°C < TA < +85°C, unless otherwise specified
General Data
Symbol Parameter
Conditions/Comments
VN
VPUP
VPP
IN
IProg
VOH
VOL
VHOH
VLEDH
ILED
VIH
VIL
ILEAKD
RPU
fclk
dfclk
Operating power supply voltage
Power-up Threshold Voltage
Ripple on supply voltage,
peak to peak
Current consumption operating
Current consumption programming
Output high voltage
Output low voltage
Output high voltage OUTH
Output high voltage LED
Source current maximum
Input high voltage
Input low voltage
Input leakage current
Pull-up resistor
Reference clock
Temperature drift
at VDD33 (and VDD)
Voltage at VDD33 when the device starts up
Input pulse IPD NST
36nA
48nA
72nA
108nA
in operation mode, IPD = 0 mA, no load
in program mode, VDD @ 8.0V, IPD = 0 mA, no load
except OUTH and LED
@ 4mA source, including OUTH and LED
see Figure 8
@ 0.1mA sink current
at Pin LED, VLED @ 0... VN - 1.0V
internal at digital input
of internal oscillator - for information only
All internal timings are referenced to this clock
of the oscillator - for information only
Min.
3
2.4
Values
Typ.
Max.
3.6
3
Units
V
VN - 0.5V
70
mV
150
mV
350
mV
600
mV
2
mA
4
mA
V
0.5
V
VN - 0.5V
0.7
0.7*VN
GND
30
32
640
1.3
VN
0.3*VN
10
200
V
mA
V
V
µA
kΩ
MHz
ppm/K
© 2011 ESPROS Photonics Corporation
2
Characteristics subject to change without notice
Datasheet epc110 - V2.1
www.espros.ch