|
GD25LQ256C Datasheet, PDF (54/68 Pages) ELM Electronics – 256M-bit Serial Flash | |||
|
◁ |
GD25LQ256CWIGx 1.8V Uniform Sector Dual and Quad Serial Flash
7.36. Burst Read with Wrap for Higher 128Mb (8DH)
http://www.elm-tech.com
The âBurst Read with Wrap for Higher 128Mb (8DH)â command provides an alternative way to perform the
read operation with âWrap Aroundâ in QPI mode. This command is similar to the âFast Read (0BH)â command
in QPI mode, except the addressing of the read operation will âWrap Aroundâ to the beginning boundary of the
âWrap Aroundâ once the ending boundary is reached. The âWrap Lengthâ and the number of dummy clocks can
be configured by the âSet Read Parameters (C0H)â command. The âBurst Read with Wrap for higher 128Mb
(8DH)â command will read out the memory content from 1000000H to 1FFFFFFH.
The âBurst Read with Wrap for Higher 128Mb (8DH)â command sequence: CS# goes low â sending The âBurst
Read with Wrap for Higher 128Mb (8DH)â command â sending 3-byte address (A23-A0, The A24 default
value is 1) â sending dummy byte â then data out.
Figure 38. Burst Read with Wrap for Higher 128Mb command Sequence Diagram
CS#
SCLK
IO0
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14
Command
8DH
20 16 12 8 4 0
IOs switch from
Input to output
4 04 0 4
IO1
21 17 13 9 5 1
5 15 1 5
IO2
22 18 14 10 6 2
6 26 2 6
IO3
23 19 15 11 7 3
7 37 3 7
A23-16
A15-8
A7-0
Dummy*
Byte1
Byte2
Byte3
*"Set Read Parameters" Command (C0H)
can set the number of dummy clocks
68 - 54
Rev.1.0
|
▷ |