GD25LQ40XIGX Datasheet, PDF (53/59 Pages) ELM Technology Corporation – 1.8V Uniform Sector Dual and Quad Serial Flash

GD25LQ40xIGx 1.8V Uniform Sector Dual and Quad Serial Flash
8.8. AC Characteristics
Symbol
Parameter
http://www.elm-tech.com
(T= -40°C~85°C, VCC=1.65~1.95V, CL=30pf)
Min. Typ. Max. Unit.
fC Serial Clock Frequency For: 0BH, 3BH, BBH, 6BH, EBH, E7H DC.
fC
Serial Clock Frequency For:
0BH, 0CH, EBH with QPI mode (4 & 6 & 8 Dummy clocks)
DC.
120 MHz
80/120/120 MHz
fR Serial Clock Frequency For: Read(03H)
tCLH Serial Clock High Time
tCLL Serial Clock Low Time
tCLCH Serial Clock Rise Time (Slew Rate)
tCHCL Serial Clock Fall Time (Slew Rate)
tSLCH CS# Active Setup Time
tCHSH CS# Active Hold Time
tSHCH CS# Not Active Setup Time
tCHSL CS# Not Active Hold Time
tSHSL CS# High Time (Read/Write)
tSHQZ Output Disable Time
tCLQX Output Hold Time
tDVCH Data In Setup Time
tCHDX Data In Hold Time
tHLCH Hold# Low Setup Time (Relative to Clock)
tHHCH Hold# High Setup Time (Relative to Clock)
tCHHL Hold# High Hold Time (Relative to Clock)
tCHHH Hold# Low Hold Time (Relative to Clock)
tHLQZ Hold# Low To High-Z Output
tHHQX Hold# Low To Low-Z Output
tCLQV Clock Low To Output Valid
tWHSL Write Protect Setup Time Before CS# Low
tSHWL Write Protect Hold Time After CS# High
tDP CS# High To Deep Power-Down Mode
tRES1 CS# High To Standby Mode Without Electronic Signature Read
tRES2 CS# High To Standby Mode With Electronic Signature Read
tSUS CS# High To Next Command After Suspend
tW Write Status Register Cycle Time
tPP Page Programming Time
tSE Sector Erase Time
tBE Block Erase Time(32K Bytes/64K Bytes)
tCE Chip Erase Time(GD25LQ40)
DC.
4
4
0.2
0.2
5
5
5
5
20
1.2
2
2
5
5
5
5
20
100
5
0.4
60
0.3/0.5
4
80
6
6
6
7
20
20
20
20
15
2.4
500
1.0/1.2
8
MHz
ns
ns
V/ns
V/ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
ns
μs
μs
μs
μs
ms
ms
ms
s
s
59 - 53
Rev.1.0