DRM-24V120W1PN Datasheet, PDF (4/20 Pages) Delta Electronics, Inc. – Universal AC input voltage range

TECHNICAL DATASHEET
CliQ M DIN Rail Power Supply
24V 120W 1 Phase / DRM-24V120W1PN
Output Ratings / Characteristics*
Nominal Output Voltage
Factory Set Point Tolerance
Output Voltage Adjustment Range
Output Current
Output Power
Power Boost Duration
Power Boost Recovery Time
Advanced Power Boost
(Slew rate 0.1A/µsec)
Nom.
Nom.
24Vdc
± 0.2% (initial set point tolerance from factory)
24-28Vdc
5.0A / 4.5A
7.5A / 6.75A
(Slew rate 0.1A/µsec)
Continuously operating at 24V / 28V
Power Boost for 5 seconds at 24V / 28V,
refer to the details in the Function section
Nom. 120W
Nom. 180W
Typ. 5 seconds
Max. 7 seconds
Typ. 14 seconds
Typ. 10A @ 50ms, resistive load
Typ. 20A @ 2ms, resistive load
Typ. 20A @ 5ms, resistive load
Continuously operating
Power Boost for 5 seconds, refer to the
details in the Functions section
Duration after which output voltage start
to droop, refer to the details in the
Function section at Overload &
Overcurrent Protections
Required wait duration before next Power
Boost is taken, refer to the details in the
Function section
Output voltage will drop (Refer to the
details in the Function section)
Line Regulation
Load Regulation
PARD**
Max.
Max.
Max.
20mV (@ 85-264Vac input, 100% load)
100mV (@ 85-264Vac input, 0-100% load)
50mVpp
20Hz to 20MHz, 50Ohm, warm up for
10mins
*For power de-rating from 60°C to 70°C, see power de-rating on page 5.
**PARD is measured with an AC coupling mode, 5cm wires, and in parallel with 0.1μF ceramic capacitor & 47μF electrolytic capacitor.
Rise Time
Start-up Time
Hold-up Time
Dynamic Response
(Overshoot & Undershoot O/P Voltage)
Start-up with Capacitive Loads
Output Capacitance
Functional
Max.
Max.
Max.
Typ.
Min.
Typ.
Min.
Max.
Max.
Typ.
DC OK Relay
Contact
100Vac 120Vac 230Vac
20ms
0µF, 24V, 5A
50ms
5,000µF, 24V, 5A
66ms
750ms
180ms
66ms
90ms
127ms
At 24V, 2.5A
At 24V, 2.5A
At 24V, 5A
34ms 34ms 65ms At 24V, 5A
± 5% @ 0-100% load
Slew rate 0.1A/µsec
(@ 5Hz, 50Hz & 1kHz, 50% Duty Cycle)
10,000µF
4,300 µF
Built-in output capacitors
Rated: 30V at 1A, resistive load
The relay contact are normally “ON” (closed) when the output (Vout) is
greater than 90% of its rated value.
4
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
www.DeltaPSU.com (December 2016, Rev. 01)