DRM-24V120W1PN Datasheet, PDF (11/20 Pages) Delta Electronics, Inc. – Universal AC input voltage range

TECHNICAL DATASHEET
CliQ M DIN Rail Power Supply
24V 120W 1 Phase / DRM-24V120W1PN
Output Load De-rating VS Input Voltage
 No output power de-rating for the input
voltage range from 85Vac to 264Vac
Assembly & Installation
The power supply unit (PSU) can be mounted on 35mm DIN rails in accordance with EN 60715. For Vertical Mounting, the device
should be installed with input terminal block at the bottom. For Horizontal Mounting, the device should be installed with input terminal
block on the left side.
Each device is delivered ready to install.
1. Tilt the unit upwards and insert it onto the DIN rail. Snap on the DIN rail as shown in Fig. 2.1.
2. Push downwards until stopped.
3. Press against the bottom front side for locking.
4. Shake the unit slightly to ensure that it is secured.
5. To uninstall, pull or slide down the latch with screw driver as shown in Fig. 2.2. Then slide the power supply unit (PSU) in the
opposite direction, release the latch and pull out the power supply unit (PSU) from the rail.
Mounting
Dismounting
Fig. 6.1 Mounting
Fig. 6.2 Dismounting
In accordance to EN 60950 / UL 60950, flexible cables require ferrules.
Use appropriate copper cables designed to sustain operating temperature of:
1. 60°C, 60°C / 75°C for USA
2. At least 90°C for Canada and IEC/EN61010-1, IEC/EN61010-2-201.
11
All parameters are specified at 25°C ambient and AC input unless otherwise indicated.
www.DeltaPSU.com (December 2016, Rev. 01)