LUPA-1300 Datasheet, PDF (7/48 Pages) Cypress Semiconductor – 1.3 M Pixel High Speed CMOS Image Sensor

LUPA-1300
Datasheet
2 Specifications
2.1 General specifications
Parameter
Pixel
architecture
Pixel size
Resolution
Pixel rate
Shutter type
Full frame
rate
Package
Specification
Remarks
6T-pixel
Based on the high-fill factor active pixel
sensor technology of FillFactory
14 µm x 14 µm
The resolution and pixel size results in a
1280 x1024
17.9 mm x 14.3 mm optical active area.
640 MHz
Using a 20 MHz system clock and 16
parallel outputs.
Pipelined snapshot Full snapshot shutter with variable
shutter
integration time
450 frames/second Frame rate increase possible with ROI read
out and/or sub sampling.
Pin grid array 145
pins
Table 1: general specifications of the LUPA sensor
2.2 Electro-optical characteristics
2.2.1 Overview
Parameter
FPN
PRNU
Conversion gain
Output signal
amplitude
Saturation
charge
Sensitivity
Fill Factor
Peak QE * FF
Peak SR * FF
MTF
Temporal Noise
Specification
<2 % RMS
20 % RMS
16 uV/electron
1V
62.500 e-
1500 V.m2/W.s
8.33 V/lux.s
21.43 V/lux.s
50%
15%
0.08 A/W
X: 67 %
Y: 66%
45e-
Remarks
<10 % p/p.
Half saturation.
Unity gain.
Is more then 60.000 (=1V/16uV/e-) due to non-
linearity in saturated region.
Average white light.
Visible band only (180 lx = 1 W/m2).
Visible + NIR (70 lx = 1 W/m2).
100%-metal and polycide coverage.
See spectral response curve.
@ Nyquist
Dark environment, measured at T=21°C.
Cypress Semiconductor Corporation 3901 North First Street
San Jose, CA 95134 408-943-2600
Contact [e-mail] Document # : 38-05711 Rev.**( Revision 3.1) Page 7 of 48