LUPA-1300 Datasheet, PDF (44/48 Pages) Cypress Semiconductor – 1.3 M Pixel High Speed CMOS Image Sensor

LUPA-1300
Datasheet
The soldering iron tip temperature should not exceed 350°C.
The soldering period for each pin should be less than 5 seconds.
Precautions and cleaning:
Avoid spilling solder flux on the cover glass; bare glass and particularly glass with
antireflection filters may be adversely affected by the flux. Avoid mechanical or
particulate damage to the cover glass.
It is recommended that isopropyl alcohol (IPA) be used as a solvent for cleaning the
image sensor glass lid. When using other solvents, it should be confirmed beforehand
whether the solvent will dissolve the package and/or the glass lid or not.
6.7 Storage conditions
Description Minimum
Temperature -10
Temperature -10
Note: RH = Relative Humidity
Maximum
66
38
Units
°C
°C
Conditions
@ 15% RH
@ 86% RH
7 Ordering Information
FillFactory Part Number
LUPA-1300-C
LUPA-1300-M
Cypress Semiconductor Part Number
CYIL1SC1300AA-GAC
CYIL1SM1300AA-GBC
Disclaimer
FillFactory image sensors are only warranted to meet the specifications as described
in the data sheet. Specifications are subject to change without notice.
Cypress Semiconductor Corporation 3901 North First Street
San Jose, CA 95134 408-943-2600
Contact [e-mail] Document # : 38-05711 Rev.**( Revision 3.1) Page 44 of 48