MB39C831 Datasheet, PDF (29/40 Pages) Cypress Semiconductor – Ultra Low Voltage Boost Power Management IC for Solar/Thermal Energy Harvesting Datasheet

MB39C831
12. Usage Precaution
Do Not Configure the IC Over the Maximum Ratings
If the IC is used over the maximum ratings, the LSI may be permanently damaged.
It is preferable for the device to be normally operated within the recommended usage conditions. Usage outside of these
conditions can have a bad effect on the reliability of the LSI.
Use the Devices within Recommended Operating Conditions
The recommended operating conditions are the recommended values that guarantee the normal operations of LSI.
The electrical ratings are guaranteed when the device is used within the recommended operating conditions and under the
conditions stated for each item.
Printed Circuit Board Ground Lines should be Set up with Consideration for Common Impedance
Take Appropriate Measures Against Static Electricity
 Containers for semiconductor materials should have anti-static protection or be made of conductive material.
 After mounting, printed circuit boards should be stored and shipped in conductive bags or containers.
 Work platforms, tools, and instruments should be properly grounded.
 Working personnel should be grounded with resistance of 250 kΩ to 1 MΩ in series between body and ground.
Do Not Apply Negative Voltages
The use of negative voltages below -0.3V may cause the parasitic transistor to be activated on LSI lines, which can cause
malfunctions.
13. Ordering Information
Table 13-1 Ordering Information
Part Number
MB39C831QN
40-pin plastic QFN
(LCC-40P-M63)
Package
14. Marking
Figure 14-1 Marking
MB 3 9 C 8 3 1
E2
INDEX
Lead free mark
Document Number: 002-08404 Rev *A
Page 29 of 40