English
Language : 

FX828 Datasheet, PDF (32/34 Pages) CML Microcircuits – CTCSS/DCS/SELCALL Processor
CTCSS/DCS/SELCALL Processor
FX828
For the following conditions unless otherwise specified:
Xtal Frequency = 4.032MHz, VDD = 3.3V to 5.0V, Tamb = -40°C to +85°C.
Parameter
tCSE
tCSH
tHIZ
tCSOFF
tNXT
tCK
"CS-Enable to Clock-High"
Last "Clock-High to CS-High"
"CS-High to Reply Output 3-state"
"CS-High" Time between transactions
"Inter-Byte" Time
"Clock-Cycle" time
Notes
Min.
2.0
4.0
-
2.0
4.0
2.0
Typ.
Max.
-
-
2.0
-
-
-
Units
µs
µs
µs
µs
µs
µs
Notes:
1. Depending on the command, 1 or 2 bytes of COMMAND DATA are transmitted to the
peripheral MSB (Bit 7) first, LSB (Bit 0) last. REPLY DATA is read from the peripheral MSB
(Bit 7) first, LSB (Bit 0) last.
2. Data is clocked into and out of the peripheral on the rising SERIAL CLOCK edge.
3. Loaded commands are acted upon at the end of each command.
4. To allow for differing µController serial interface formats "C-BUS" compatible ICs are able
to work with either polarity SERIAL CLOCK pulses.
© 2009 CML Microsystems Plc
32
D/828/4