CDB5378 Datasheet, PDF (48/72 Pages) Cirrus Logic – Single-channel Seismic Evaluation System

CDB5378
3.4.5 Zoom
The ZOOM function allows an area on the graph to be expanded.
To use the zoom function, click the ZOOM button and select the box corners of the area on the graph to
expand. The graph will then expand to show the details of this area, and the plot axes will be re-scaled.
While zoomed, you can zoom in farther by repeating the process.
To restore the graph to its original scale, click the RESTORE button that appears while zoomed. If mul-
tiple zooms have been initiated, the RESTORE button will return to the previously viewed plot scale. Re-
peated RESTORE will eventually return to the original plot scale. From within multiple zooms the original
scale can be directly restored by clicking the REFRESH button.
3.4.6 Refresh
The REFRESH button will clear and re-plot the current data set. Refresh can be used to apply new anal-
ysis parameters from the Data Capture sub-panel, or to restore a ZOOM graph to its default plot scale.
3.4.7 Harmonics
The HARMONICS control is only visible during a Signal FFT analysis and highlights the fundamental and
harmonic bins used to calculate the Signal FFT statistics. HARMONICS highlighting helps to understand
the source of any Signal FFT plot errors.
3.4.8 Spot Noise
The Spot Noise control (labeled dB or nV) is only visible during a Noise FFT analysis and selects the units
used for plotting the graph, either dB/Hz or nV/rtHz. The dB/Hz plot applies the Full Scale Code value from
the Data Capture sub-panel on the Setup panel to determine the 0 dB point of the dB axis. The nV/rtHz
plot applies the Full Scale Voltage value from the Data Capture sub-panel on the Setup panel to deter-
mine the absolute scaling of the nV axis.
3.4.9 Plot Error
The PLOT ERROR control provides information about errors that occured during an analysis.
An analysis error stores an error code in the numerical display box of the PLOT ERROR control. If more
than one error occurs, all error codes are stored and the last error code is displayed. Any of the accumu-
lated error codes can be displayed by clicking on the numerical box and selecting it.
Once an error code is displayed in the numerical box, a description can be displayed by clicking the PLOT
ERROR button. This causes a dialog box to display showing the error number and a text error message.
48
DS639DB3