CS4215 Datasheet, PDF (11/52 Pages) Cirrus Logic – 16-Bit Multimedia Audio Codec

FSYNC
SCLK
CLKOUT
8.5 CLKOUT's
11 CLKOUT's
Data Mode -Read and Write
PIO Read
PIO Write
TSIN
SCLK
PIO Read
1 SCLK
Control Mode - Read Only
Notes:
1. DATA MODE READ - The data is sent out via SDOUT on the next frame.
2. CONTROL MODE READ - The data is sent out, via SDOUT, the same frame.
3. DATA MODE READ, WRITE - are tied to the rising edge of FSYNC and CLKOUT.
They are independent of SCLK.
4. CONTROL MODE READ - The PIO pins are sampled by a rising edge of SCLK.
Figure 5. PIO Pin Timing
CS4215
after power up. A calibration cycle will occur
immediately after leaving the reset state. A cali-
bration cycle will also occur immediately after
going from control mode to data mode (D/C go-
ing high). When powering up the CS4215, or
exiting the power down state, a minimum of
50 ms must occur, to allow the voltage reference
to settle, before initiating a calibration cycle.
This is achieved by holding RESET low or stay-
ing in control mode for 50 ms after power up or
exiting power down mode. The input offset error
will be calibrated for whichever input channel is
selected (microphone or line, using the IS bit).
Therefore, the IS bit should remain steady while
the codec is calibrating, although the other bits
input to the codec are ignored. Calibration takes
194 FSYNC cycles and SDOUT data bits will be
zero during this period. The A/D Invalid bit, ADI
(bit 7 in data time slot 6), will be high during
calibration and will go low when calibration is
finished.
Parallel Input/Output
Two pins are provided for parallel input/output.
These pins are open drain outputs and require
external pull-up resistors. Writing a zero turns on
the output transistor, pulling the pin to ground;
writing a one turns off the output transistor,
which allows an external resistor to pull the pin
high. When used as an input, a one must be writ-
ten to the pin, thereby allowing an external
device to pull it low or leave it high. These pins
can be read in control mode and their state is
recorded in Control Register 5. These pins can
be written to and read back in data mode using
Data Register 7. Figure 5 shows the Parallel In-
put/Output timing.
DS76F2
11