HCPL-316J Datasheet, PDF (6/33 Pages) AVAGO TECHNOLOGIES LIMITED – 2.5 Amp Gate Drive Optocoupler with Integrated (VCE) Desaturation Detection and Fault Status Feedback

Package Characteristics
All specifications and figures are at the nominal (typical) operating conditions of V_CC1 = 5 V, V_CC2 - V_EE = 30 V,
V_E - V_EE = 0 V, and T_A = +25°C.
Parameter
Symbol Min. Typ. Max. Units Test Conditions
Note
Input-Output Momentary
V_ISO
3750
V_rms
Withstand Voltage
Resistance (Input-Output)
R_I-O
>10⁹
Ω
RH < 50%, t = 1 min., 1, 2,
T_A = 25°C
3
V_I-O = 500 Vdc
3
Capacitance (Input-Output)
Output IC-to-Pins 9 &10
Thermal Resistance
C_I-O
q_O9-10
1.3
30
pF
°C/W
f = 1 MHz
T_A = 100°C
Input IC-to-Pin 4 Thermal Resistance
q_I4
60
Solder Reflow Thermal Profile
300
PREHEATING RATE 3 °C + 1 C/–0.5 °C/SEC.
REFLOW HEATING RATE 2.5 °C ± 0.5 °C/SEC.
PEAK
TEMP.
245 °C
200
160 °C
150 °C
140 °C
100
2.5 °C ± 0.5 °C/SEC.
3 °C + 1 °C/–0.5 °C
PREHEATING TIME
150 °C, 90 + 30 SEC.
30
SEC.
30
SEC.
PEAK
TEMP.
240 °C
SOLDERING
TIME
200 °C
PEAK
TEMP.
230 °C
50 SEC.
ROOM
TEMPERATURE
0
0
TIGHT
TYPICAL
LOOSE
50
100
150
200
250
TIME (SECONDS)
Note: Non-halide flux should be used.
Recommended Pb-Free IR Profile
t_p
T_p
T_L
T_smax
T_smin
260 +0/-5 °C
217 °C
RAMP-UP
3°C/SEC. MAX.
150 - 200°C
t_s
PREHEAT
t_L
60 to 180 SEC.
TIME WITHIN 5°C of ACTUAL
PEAK TEMPERATURE
20-40 SEC.
RAMP-DOWN
6°C/SEC. MAX.
60 to 150 SEC.
25
t 25°C to PEAK
TIME
NOTES:
THE TIME FROM 25 C to PEAK TEMPERATURE = 8 MINUTES MAX.
T_smax = 200°C, T_smin = 150°C
Note: Non-halide flux should be used.