HCPL-316J Datasheet, PDF (10/33 Pages) AVAGO TECHNOLOGIES LIMITED – 2.5 Amp Gate Drive Optocoupler with Integrated (VCE) Desaturation Detection and Fault Status Feedback

Switching Specifications (AC)
Unless otherwise noted, all typical values at T_A = 25°C, V_CC1 = 5 V, and V_CC2 - V_EE = 30 V, V_E - V_EE = 0 V;
all Minimum/Maximum specifications are at Recommended Operating Conditions.
Parameter   Symbol Min. Typ. Max. Units Test Conditions     Fig. Note
V_IN to High Level Output
t_PLH
0.10 0.30 0.50 µs
Propagation Delay Time
V_IN to Low Level Output
t_PHL
0.10 0.32 0.50
Propagation Delay Time
Rg = 10 Ω
Cg = 10 nF,
f = 10 kHz,
Duty Cycle = 50%
17,18,19, 15
20,21,22,
45,54,55
Pulse Width Distortion
PWD
-0.30 0.02 0.30
16,17
Propagation Delay Difference
Between Any Two Parts
(t_PHL - t_PLH)
PDD
-0.35
0.35
17,18
10% to 90% Rise Time
t_r
0.1
90% to 10% Fall Time
t_f
0.1
DESAT Sense to 90% V_OUT Delay
t_DESAT(90%)
0.3 0.5

Rg = 10 Ω,
Cg = 10 nF
45
23,56
19
DESAT Sense to 10% V_OUT Delay
t_DESAT(10%)
2.0 3.0
V_CC2 - V_EE = 30 V

24,28,
46,56
DESAT Sense to Low Level FAULT
t_DESAT(FAULT)
1.8 5
Signal Delay
25,47, 20
56
DESAT Sense to DESAT Low
Propagation Delay
t_DESAT(LOW)
0.25
56
21
RESET to High Level FAULT Signal
t_RESET(FAULT) 3
7
20
Delay
26,27, 22
56
RESET Signal Pulse Width
UVLO to V_OUT High Delay
UVLO to V_OUT Low Delay
PW_RESET
0.1
t_{UVLO ON}
4.0
V_CC2 = 1.0 ms
49
13
t_{UVLO OFF}
6.0
ramp
14
Output High Level Common Mode |CM_H|
15 30
kV/µs
Transient Immunity

T_A = 25°C,
V_CM = 1500 V,
V_CC2 = 30 V
50,51, 23
52,53
Output Low Level Common Mode |CM_L|
15 30
T_A = 25°C,
24
Transient Immunity
V_CM = 1500 V,

V_CC2 = 30 V
10