HCPL-M600500 Datasheet, PDF (3/11 Pages) AVAGO TECHNOLOGIES LIMITED – Small Outline, 5 Lead, High CMR, High Speed, Logic Gate Optocouplers

Outline Drawing (JEDEC MO-155)
4.4 ± 0.1
(0.173 ± 0.004)
MXXX
XXX
ANODE 1
7.0 ± 0.2
(0.276 ± 0.008)
CATHODE 3
6 V_CC
5 V_OUT
4 GND
0.4 ± 0.05
(0.016 ± 0.002)
3.6 ± 0.1*
(0.142 ± 0.004)
2.5 ± 0.1
(0.098 ± 0.004)
0.102 ± 0.102
(0.004 ± 0.004)
1.27 _BSC
(0.050)
(00..07218)MIN.
DIMENSIONS IN MILLIMETERS (INCHES)
* MAXIMUM MOLD FLASH ON EACH SIDE IS 0.15 mm (0.006)
NOTE: FLOATING LEAD PROTRUSION IS 0.15 mm (6 mils) MAX.
0.216 ± 0.038
(0.0085 ± 0.0015)
7° MAX.
MAX. LEAD COPLANARITY
= 0.102 (0.004)
Land Pattern Recommendation
4.4
(0.17)
2.5
(0.10)
2.0
(0.080)
8.27
(0.325)
1.3
(0.05)
0.64
(0.025)
Schematic
+ IF
1
I_CC
6 ^VCC
I_{O 5 VO}
–
3
HCPL-M601/11 SHIELD
USE OF A 0.1 μF BYPASS CAPACITOR
MUST BE CONNECTED BETWEEN PINS
6 AND 4 (SEE NOTE 1).
GND
4
TRUTH TABLE
(POSITIVE LOGIC)
LED OUTPUT
ON
L
OFF
H
Regulatory Information
The HCPL-M600, HCPL-M601 and HCPL-M611 are approved by the following organizations:
IEC/EN/DIN EN 60747-5-5 (Option 060 only)
UL
for HCPL-M601 and HCPL-M611
Approval under UL 1577, component recognition pro-
gram up to V_ISO = 3750 V_RMS.
CSA
Approval under CSA Component Acceptance Notice #5,
File CA 88324.
3