ATMEGA128RFA1_11 Datasheet, PDF (431/560 Pages) ATMEL Corporation – 8-bit Microcontroller with Low Power 2.4GHz Transceiver for ZigBee and IEEE 802.15.4

ATmega128RFA1
MUX5:0
101100
101101
101110
101111
110000
110001
110010
110011
110100
110101
110110
110111
111000
111001
111010
111011
111100
111101
111110
111111
Single Ended
Input
N/A
N/A
Reserved
Reserved
Positive Differential Negative Differential
Input
Input
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
SRAM Back-bias Voltage VDRTBBP
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
SRAM Back-bias Voltage VDRTBBN
N/A
Gain
• Bits 2:0 – ADTS2:0: ADC Auto Trigger Source
If ADATE in ADCSRA is written to one, the value of these bits selects which source will
trigger an A/D conversion. If ADATE is cleared, the ADTS2:0 settings will have no
effect. A conversion will be triggered by the rising edge of the selected Interrupt Flag.
Note that switching from a trigger source that is cleared, to a trigger source that is set,
will generate a positive edge on the trigger signal. If ADEN in ADCSRA is set, this will
start a conversion. Switching to Free Running mode (ADTS2:0=0) will not cause a
trigger event, even if the ADC Interrupt Flag is set.
Table 27-12. ADC Auto Trigger Source Selections
ADTS2
ADTS1
ADTS0
Trigger Source
0
0
0
Free Running mode
0
0
1
Analog Comparator
0
1
0
External Interrupt Request 0
0
1
1
Timer/Counter0 Compare Match A
1
0
0
Timer/Counter0 Overflow
1
0
1
Timer/Counter1 Compare Match B
1
1
0
Timer/Counter1 Overflow
1
1
1
Timer/Counter1 Capture Event
8266C-MCU Wireless-08/11
431