ATXMEGA128B1 Datasheet, PDF (40/138 Pages) ATMEL Corporation – 8/16-bit Atmel XMEGA B1 Microcontroller

22. TWI – Two Wire Interface
22.1
Features
• One two-wire interface peripheral
• Bidirectional, two-wire communication interface
– Phillips I²C compatible
– System Management Bus (SMBus) compatible
• Bus master and slave operation supported
– Slave operation
– Single bus master operation
– Bus master in multi-master bus environment
– Multi-master arbitration
• Flexible slave address match functions
– 7-bit and general call address recognition in hardware
– 10-bit addressing supported
– Address mask register for dual address match or address range masking
– Optional software address recognition for unlimited number of addresses
• Slave can operate in all sleep modes, including power-down
• Slave address match can wake device from all sleep modes
• 100kHz and 400kHz bus frequency support
• Slew-rate limited output drivers
• Input filter for bus noise and spike suppression
• Support arbitration between start/repeated start and data bit (SMBus)
• Slave arbitration allows support for address resolve protocol (ARP) (SMBus)
22.2
Overview
The two-wire interface (TWI) is a bidirectional, two-wire communication interface. It is I²C and System Management Bus
(SMBus) compatible. The only external hardware needed to implement the bus is one pull-up resistor on each bus line.
A device connected to the bus must act as a master or a slave. The master initiates a data transaction by addressing a
slave on the bus and telling whether it wants to transmit or receive data. One bus can have many slaves and one or
several masters that can take control of the bus. An arbitration process handles priority if more than one master tries to
transmit data at the same time. Mechanisms for resolving bus contention are inherent in the protocol.
The TWI module supports master and slave functionality. The master and slave functionality are separated from each
other, and can be enabled and configured separately. The master module supports multi-master bus operation and
arbitration. It contains the baud rate generator. Both 100kHz and 400kHz bus frequency is supported. Quick command
and smart mode can be enabled to auto-trigger operations and reduce software complexity.
The slave module implements 7-bit address match and general address call recognition in hardware. 10-bit addressing is
also supported. A dedicated address mask register can act as a second address match register or as a register for
address range masking. The slave continues to operate in all sleep modes, including power-down mode. This enables
the slave to wake up the device from all sleep modes on TWI address match. It is possible to disable the address
matching to let this be handled in software instead.
The TWI module will detect START and STOP conditions, bus collisions, and bus errors. Arbitration lost, errors, collision,
and clock hold on the bus are also detected and indicated in separate status flags available in both master and slave
modes.
It is possible to disable the TWI drivers in the device, and enable a four-wire digital interface for connecting to an external
TWI bus driver. This can be used for applications where the device operates from a different V_CC voltage than used by
the TWI bus.
PORTC has one TWI. Notation of this peripheral is TWIC.
XMEGA B1 [DATASHEET] 40
8330C–AVR–07/2012