|
ATXMEGA128B1 Datasheet, PDF (1/138 Pages) ATMEL Corporation – 8/16-bit Atmel XMEGA B1 Microcontroller | |||
|
Features
8/16-bit Atmel XMEGA B1 Microcontroller
ATxmega128B1; ATxmega64B1
ï¬ High-performance, low-power Atmel® AVR® XMEGA® 8/16-bit Microcontroller
ï¬ Nonvolatile program and data memories
ï¬ 64K - 128KBytes of in-system self-programmable flash
ï¬ 4K - 8KBytes boot section
ï¬ 2KBytes EEPROM
ï¬ 4K - 8KBytes internal SRAM
ï¬ Peripheral Features
ï¬ Two-channel DMA controller
ï¬ Four-channel event system
ï¬ Three 16-bit timer/counters
ï¬ Two timer/counters with 4 output compare or input capture channels
ï¬ One timer/counter with 2 output compare or input capture channels
ï¬ High resolution extensions one timer/counter
ï¬ Advanced waveform extension (AWeX) on one timer/counter
ï¬ Split mode on two timer/counters
ï¬ One USB device interface
ï¬ USB 2.0 full speed (12Mbps) and low speed (1.5Mbps) device compliant
ï¬ 32 Endpoints with full configuration flexibility
ï¬ Two USARTs with IrDA support for one USART
ï¬ AES and DES crypto engine
ï¬ CRC-16 (CRC-CCITT) and CRC-32 (IEEE® 802.3) generator
ï¬ One two-wire interface with dual address match (I2C and SMBus compatible)
ï¬ One serial peripheral interface (SPI)
ï¬ 16-bit Real Time Counter (RTC) with separate oscillator
ï¬ Liquid Crystal Display
ï¬ Up to 4x40 segment driver
ï¬ Built in contrast control
ï¬ ASCII character mapping
ï¬ Flexible SWAP of segment and common terminals buses
ï¬ Two eight-channel, 12-bit, 300 thousand SPS Analog to Digital Converters
ï¬ Four Analog Comparators with window compare function, and current source
feature
ï¬ External interrupts on all General Purpose I/O pins
ï¬ Programmable watchdog timer with separate on-chip ultra low power oscillator
ï¬ QTouch® library support
ï¬ Capacitive touch buttons, sliders and wheels
ï¬ Special microcontroller features
ï¬ Power-on reset and programmable brown-out detection
ï¬ Internal and external clock options with PLL
ï¬ Programmable multilevel interrupt controller
ï¬ Five sleep modes
ï¬ Programming and debug interfaces
ï¬ JTAG (IEEE 1149.1 Compliant) interface, including boundary scan
ï¬ PDI (Program and Debug Interface)
ï¬ I/O and Packages
ï¬ 53 Programmable I/O pins
ï¬ 100-lead TQFP
ï¬ Operating Voltage
ï¬ 1.6 â 3.6V
ï¬ Operating frequency
ï¬ 0 â 12MHz from 1.6V
ï¬ 0 â 32MHz from 2.7V
8330CâAVRâ07/2012
|
▷ |