AT24C02C Datasheet, PDF (18/23 Pages) ATMEL Corporation – Two-wire Serial Electrically Erasable and Programmable Read-only Memory

8A2 – TSSOP
3 21
Pin 1 indicator
this corner
E1
E
L1
N
Top View
L
End View
COMMON DIMENSIONS
(Unit of Measure = mm)
A
b
e
A2
D
Side View
SYMBOL
D
E
E1
A
A2
b
e
L
L1
MIN
2.90
4.30
–
0.80
0.19
0.45
NOM
3.00
6.40 BSC
4.40
–
1.00
–
0.65 BSC
0.60
1.00 REF
MAX
3.10
4.50
1.20
1.05
0.30
0.75
NOTE
2, 5
3, 5
4
Notes:
1. This drawing is for general information only. Refer to JEDEC Drawing MO-153, Variation AA, for proper dimensions,
tolerances, datums, etc.
2. Dimension D does not include mold Flash, protrusions or gate burrs. Mold Flash, protrusions and gate burrs shall
not exceed 0.15mm (0.006in) per side.
3. Dimension E1 does not include inter-lead Flash or protrusions. Inter-lead Flash and protrusions shall not exceed
0.25mm (0.010in) per side.
4. Dimension b does not include Dambar protrusion. Allowable Dambar protrusion shall be 0.08mm total in excess
of the b dimension at maximum material condition. Dambar cannot be located on the lower radius of the foot.
Minimum space between protrusion and adjacent lead is 0.07mm.
5. Dimension D and E1 to be determined at Datum Plane H.
5/19/10
TITLE
Package Drawing Contact: 8A2, 8-lead 4.4mm Body, Plastic Thin
[e-mail] _{Shrink Small Outline Package (TSSOP)}
GPC DRAWING NO. REV.
TNR
8A2
E
18 Atmel AT24C02C
8700D–SEEPR–8/10